Detail 01
Dynamic with neodymium magnet
No phantom power needed. Handles high volume and rough handling better than a condenser, at the cost of high-frequency detail.

Independent shopping perspective
Utility-version dynamic cardioid built for close-miked loud sources. For live vocals, kick drum, and toms where a condenser would be too fragile or too open.

Strong match
Consider the trade-offs
What matters in use
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 01
No phantom power needed. Handles high volume and rough handling better than a condenser, at the cost of high-frequency detail.
Detail 02
Rolls off below 50Hz, which naturally trims stage rumble and floor thump on a loud stage.
Detail 03
Fairly low output. Cheap preamps may need to be pushed near maximum gain, which can add hiss on quiet sources.
Detail 04
Standard balanced impedance. Runs long XLR cable to the board without noise pickup or high-end loss.
Detail 05
Rejects what's directly behind it, so you can point the back at a wedge monitor to reduce feedback.
Detail 06
Survives being knocked over, dropped in a gig bag, and repeated stage handling.
Final check
Product questions
Straight answers to the questions shoppers most often ask about this product.
No. It's a dynamic mic and works off any standard mic input. Phantom power on the channel won't harm it, but it does nothing.
Utility. It's the stripped-back version of the PR 22, so accessories and packaging differ from the standard model. Verify what mount ships with yours.
Yes. A cardioid dynamic with a 50Hz low end handles kick well, though you'll get less sub-thump than from a dedicated kick mic.
Yes, through any XLR mic input. You'll need a decent preamp since output is low at -55dB.
Reference
The complete catalog record, organized around the decisions musicians make when comparing gear.