Detail 01
Two response curves, kick and general
Kick curve reaches to 30Hz with a mid scoop already built in. General curve starts at 45Hz for flatter, broader use.

Independent shopping perspective
Cardioid dynamic mic with a switchable kick-drum curve. Built for kick, bass cabs, and broadcast voice where a shaped response saves EQ time.


Strong match
Consider the trade-offs
What matters in use
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.

Detail 01
Kick curve reaches to 30Hz with a mid scoop already built in. General curve starts at 45Hz for flatter, broader use.
Detail 02
No phantom power, no clipping on loud sources. Stronger magnet means more output than a typical dynamic of this size.
Detail 03
Rejects what is behind it. On a drum kit that means less hi-hat and snare bleed into the kick channel.
Detail 04
Standard low impedance. Works with any mic preamp and tolerates long cable runs without high-end loss.
Detail 05
Shrugs off magnetic hum from lighting dimmers, transformers, and computer monitors — relevant in broadcast booths.
Detail 06
Heavy and long for a dynamic. Plan mic placement inside a kick drum and check your stand can hold it.
Final check

Product questions
Straight answers to the questions shoppers most often ask about this product.
No. It is a dynamic mic and works off any standard mic preamp. Phantom power will not harm it if your interface applies it globally.
Both. Use the general curve for voice, which runs 45Hz to 18kHz. The kick curve reaches lower and is shaped for drums.
Yes. Dynamic mics have no active circuitry to overload, so high SPL sources are what this design is built around.
Confirm mounting hardware with your seller before ordering. At 1 lb 8 oz and 8.5 inches, it needs a sturdy clip and stand either way.
Reference
The complete catalog record, organized around the decisions musicians make when comparing gear.