Detail 01
40W power rating
Comfortable for most 1x10 and 2x10 guitar amps. Enough margin that it will not be the first thing to fail.

Independent shopping perspective
A 10-inch alnico guitar speaker, 40 watts at 8 ohms. Suits smaller combos and 4x10 cabs where you want alnico feel with usable headroom.

Strong match
Consider the trade-offs
What matters in use
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 01
Comfortable for most 1x10 and 2x10 guitar amps. Enough margin that it will not be the first thing to fail.
Detail 02
Softer attack and a compressed feel when driven hard, compared with a ceramic speaker's firmer, more linear response.
Detail 03
Less low end and a tighter, more focused midrange than a 12. Faster response, smaller cabinet.
Detail 04
Common single-speaker load. Two in parallel give 4 ohms, two in series 16 — check what your amp accepts.
Final check
Product questions
Straight answers to the questions shoppers most often ask about this product.
No. It is a 10-inch frame with a smaller cutout and different bolt spacing. You would need an adapter baffle or a new baffle board.
Four of these give 160 watts total. Wired in series-parallel, four 8-ohm speakers land back at 8 ohms.
Alnico compresses and softens as you push it. Ceramic stays firm and tends to run louder for the same input. Pick alnico if you want the amp to feel spongier.
Yes, with margin. Power ratings are for the speaker's handling, and 40 comfortably covers a 30-watt amp on one speaker.
Reference
The complete catalog record, organized around the decisions musicians make when comparing gear.