Detail 01
Mono 1/4 in (TS) on both ends
Unbalanced, one signal path. It won't carry a stereo pair or the cold leg of a balanced connection.
Product detailSKU #1275776902296
MogamiPure Patch 1/4" Plug to 1/4" Mono Hi-Definition Patch Cable 10 ft.
Independent shopping perspective
The Korena take
A 10 ft mono 1/4 in patch cable from Mogami. For runs between rack gear, patch bays, or a board and an amp where 10 feet is the right length.
Strong match
Who this is for
- Patch bay to outboard gear in a studio rack
- Board-to-amp runs where you need real length
- Replacing a noisy cable in a fixed installation
Consider the trade-offs
When to look elsewhere
- Short pedal-to-pedal hops — 10 feet coils up on the board
- Balanced line-level runs needing TRS connections
- Speaker duty between a head and cabinet
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
10 ft length
Enough to cross a rack or reach an amp a few steps away. Excess coils rather than pulls tight.
Detail 03
Patch cable, not speaker cable
Shielded for low-level signal. Running amp output through it risks the cable and the amp.
Detail 04
Straight 1/4 in plugs
Plugs project straight out of the jack, so rear-panel gear needs clearance behind the rack.
Final check
Know before you order
- 01Confirm your gear uses unbalanced 1/4 in — TRS jacks need a TRS cable to stay balanced
- 02Sold as one cable; patch bay work usually needs a handful
- 03Coil excess in loose loops rather than tight wraps to protect the jacket
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01What's the difference between this and an instrument cable?
Both are shielded, unbalanced 1/4 in mono. This length suits gear-to-gear runs in a rack or between a board and an amp rather than guitar-to-amp duty.
02Can I use this for a balanced connection?
No. It's mono TS, so a balanced TRS jack will connect but run unbalanced. For balanced line-level runs, use a TRS or XLR cable.
03Is 10 feet too long for a pedalboard?
For pedal-to-pedal, yes — you'd be coiling most of it. It suits the run from the board to the amp, or between separated pieces of gear.
04Can this connect an amp head to a speaker cabinet?
No. Shielded signal cable isn't built for amplifier output. Use a proper unshielded speaker cable rated for your amp's power.
Reference
Full specifications
The complete catalog record, organized around the decisions musicians make when comparing gear.
1 detailsBody & build
- Color
- Black
