Detail 01
Mono 1/4" (TS) on both ends
Unbalanced signal. Fine for instrument and pedal runs, but it won't reject hum on long studio lines.
Product detailSKU #1275776902287
MogamiPure Patch 1/4" Plug to 1/4" Mono Hi-Definition Patch Cable 15 ft.
Independent shopping perspective
The Korena take
A 15 ft. patch cable with 1/4" plugs for linking pedals, rack gear or amp channels. For players who want one durable, low-noise connection.
Strong match
Who this is for
- Connecting an amp head to a cabinet or effects loop
- Runs between rack units where a short patch cable won't reach
- Pedalboard-to-amp runs that need slack for repositioning
Consider the trade-offs
When to look elsewhere
- Anyone patching adjacent pedals — 15 ft. is far too long
- Shoppers who need balanced TRS or XLR connections
- Budget builds where a $15 cable does the same job
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
15 ft. length
Enough slack to move around a small stage or reach across a rack without coiling excess on the floor.
Detail 03
Straight plugs on both ends
Sticks straight out of the jack. Tight against a wall or in a shallow rack, a right-angle end would sit flatter.
Detail 04
$51.95 for a patch cable
You're paying for conductor and shield quality, not features. The benefit is lower noise and a longer service life.
Detail 05
Black jacket
Disappears on a dark stage and behind racks. Harder to trace in a tangle than a colored cable.
Final check
Know before you order
- 01Cable only — no adapters, ties or pouch included
- 02Confirm your gear takes unbalanced TS, not TRS or XLR
- 03Coil it over-under; sharp bends at the plug kill cables first
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Can I use this as a guitar cable?
Yes. It's an unbalanced 1/4" mono cable, which is exactly what a guitar-to-amp or guitar-to-pedal run needs. 15 ft. is a common stage length.
02Will this work in an amp effects loop?
Yes, for the send or return. Standard amp loops use unbalanced 1/4" jacks. You'll need two cables to complete the loop.
03Is it a speaker cable?
No. This is an instrument-level patch cable. Use a dedicated speaker cable between an amp head and cabinet.
04Why is a patch cable this expensive?
The cost is in conductor and shielding quality. A cheap cable passes signal too; this one stays quieter and survives more plugging cycles.
Reference
Full specifications
The complete catalog record, organized around the decisions musicians make when comparing gear.
1 detailsBody & build
- Color
- Black
