Korena
Product detailSKU #1273887988802

Audio-TechnicaATM410 Cardioid Dynamic Vocal Microphone

Audio-Technica logo
Audio-Technica ATM410 Cardioid Dynamic Vocal Microphone
1/3

Independent shopping perspective

The Korena take

An $89 cardioid dynamic vocal mic for stages and rehearsal rooms. Straightforward handheld that needs no power and tolerates hard use.

Audio-Technica ATM410 Cardioid Dynamic Vocal Microphone product detail
Product studyAudio-Technica ATM410 Cardioid Dynamic Vocal Microphone
Audio-Technica ATM410 Cardioid Dynamic Vocal Microphone alternate view
Alternate view

Strong match

Who this is for

  • First stage vocal mic for a gigging band
  • Loud rooms where a condenser would pick up too much bleed
  • Rehearsal spaces and PA kits where mics get moved constantly

Consider the trade-offs

When to look elsewhere

  • Studio vocal tracking where you want detail and air
  • Acoustic guitar or cymbals — the response rolls off both extremes
  • Quiet, breathy singers who need a more sensitive capsule

What matters in use

The specifications, translated

Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.

Detail 01

Dynamic element

No power needed and it shrugs off drops and heat. Less detailed than a condenser, and far less prone to feedback.

Detail 02

90Hz–16kHz frequency response

Rolls off below 90Hz, cutting stage rumble and handling thump before it ever reaches the mix.

Detail 03

Cardioid pattern

Rejects sound from behind, so a wedge can sit directly in front of the singer.

Detail 04

-55dB sensitivity

Quieter output than a condenser. You'll run the channel gain noticeably higher to reach the same level.

Detail 05

300 ohm impedance

Standard low-Z output. Works with any XLR mic input and tolerates long cable runs.

Detail 06

233g, 6.69 inches long

Compact and light for a handheld. Fits standard clips and slides into a gig-bag pocket.

Final check

Know before you order

  1. 01XLR cable not included; clamp, thread adapter and pouch are
  2. 02Phantom power isn't needed, and leaving it on does no harm
  3. 03Expect to add preamp gain — output is lower than a condenser's

Product questions

Before you decide

Straight answers to the questions shoppers most often ask about this product.

01Does the ATM410 need phantom power?

No. It's a dynamic mic and generates its own signal. Phantom power on the channel won't hurt it, but it isn't required.

02Is it good for recording vocals at home?

It works, and it hides room noise better than a condenser. Expect a darker, less detailed sound and plan on more preamp gain.

03What's included?

The mic, an AT8470 clamp for 5/8-27 stands, a 5/8-27 to 3/8-16 thread adapter and a soft pouch. No cable.

04Will it feed back on a small stage?

Less than a condenser will. The cardioid pattern and the rolloff below 90Hz both help. Keep wedges behind the mic, not off to the side.

Reference

Full specifications

The complete catalog record, organized around the decisions musicians make when comparing gear.

3 detailsSound
Polar Pattern
Cardioid
Frequency Response
90Hz–16kHz
Impedance
300 ohms
1 detailsPickups & controls
Open Circuit Sensitivity
-55dB (1.7 mV) re 1V at 1 Pa
1 detailsBody & build
Color
Black
1 detailsConnections & power
Output Connector
Integral 3-pin XLRM-type
2 detailsSize & weight
Weight
233
Dimensions
170 mm (6.69 inch) long, 53.5 mm (2.11 inch) diameter
1 detailsIn the box
Audio Technica Case Style
T6
2 detailsOther
Accessories Furnished
AT8470 Quiet-Flex stand clamp for 5/8 inch-27 threaded stands; 5/8 inch-27 to 3/8 inch-16 threaded adapter; soft protective pouch
Element
Dynamic

Complete your setup

Worth comparing

More from Audio-Technica