Detail 01
Cardioid pattern
Picks up mostly what's in front, rejects the rear. Point the back of the mic at your monitor to reduce feedback.
Product detailSKU #1327507869321
Audio-TechnicaATM510 Cardioid Dynamic Vocal Mic Featuring Advanced Internal Shock Mounting
1/5
Independent shopping perspective
The Korena take
A cardioid dynamic vocal mic with internal shock mounting. For live vocals on stage or anyone needing a durable handheld that rejects stage noise.
Strong match
Who this is for
- Live vocals where stage bleed and monitor feedback are problems
- Handheld use where cable and handling noise matter
- Backup or spare mic in a working gig bag
Consider the trade-offs
When to look elsewhere
- Studio vocal detail — the 16kHz ceiling limits air and sparkle
- Recording room ambience or drum overheads
- Anyone needing USB or plug-and-play computer connection
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Internal shock mounting
Suspends the capsule inside the body, so grip noise and cable thumps don't travel into the signal.
Detail 03
90Hz–16kHz response
Rolls off below 90Hz to cut stage rumble and proximity boom. Trades top-end air for a focused vocal band.
Detail 04
-55 dB sensitivity
Fairly low output, typical of dynamics. Needs a decent preamp with headroom, not a weak built-in input.
Detail 05
3-pin XLR output
Standard balanced connection. Runs long cable lengths without noise, but requires an XLR input, not 1/4 inch or USB.
Detail 06
0.57 lb, 6-11/16 inch long
Standard handheld weight and length. Fits any generic mic clip and sits comfortably in hand for a full set.
Final check
Know before you order
- 01No XLR cable included — you'll need one to connect anything
- 02Ships with a stand clamp, 5/8-to-3/8 thread adapter, and pouch
- 03No stand included. Confirm your stand thread matches 5/8 inch-27 or use the adapter
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Does this need phantom power?
No. It's a dynamic mic and works on any standard XLR input without phantom power. Leaving phantom on won't harm it either.
02Will it fit a standard mic stand?
Yes. The included clamp threads onto 5/8 inch-27 stands, and the included adapter converts it to 3/8 inch-16 for European stands.
03Can I plug it into my computer?
Not directly. You'll need an audio interface or mixer with an XLR input and a mic preamp.
04Is it good for recording vocals at home?
It'll work, but the response stops at 16kHz, so it's darker than a condenser. It's built for live vocals first.
Reference
Full specifications
The complete catalog record, organized around the decisions musicians make when comparing gear.
3 detailsSound
- Polar Pattern
- Cardioid
- Frequency Response
- 90Hz-16kHz
- Impedance
- 300 ohms
1 detailsPickups & controls
- Open Circuit Sensitivity
- -55 dB (1.7 mV) re 1V at 1 Pa
1 detailsBody & build
- Color
- Black
1 detailsConnections & power
- Output Connector
- Integral 3-pin XLRM-type
2 detailsSize & weight
- Weight
- 0.57
- Dimensions
- 6-11/16 inch (170mm) long; 2-1/8 inch (53.7mm) diameter
1 detailsIn the box
- Audio Technica Case Style
- T6
2 detailsOther
- Accessories
- AT8470 Quiet-Flex stand clamp for 5/8 inch-27 threaded stands; 5/8 inch-27 to 3/8 inch-16 threaded adapter; soft protective pouch
- Element
- Dynamic
