Detail 01
6 mm thread size
Fits stands with 6 mm tilter rods. An 8 mm rod will not pass through, so check your stand first.
Product detailSKU #1274115064969
Sound Percussion LabsWing Cymbal Sleeve 4-Pack 6 mm
Independent shopping perspective
The Korena take
Four-pack of plastic cymbal sleeves for 6 mm stand threads. For drummers replacing worn sleeves that let cymbals contact bare metal.
Strong match
Who this is for
- Restocking after old sleeves split, flattened, or went missing
- Protecting cymbal bell holes on stands and hi-hat clutches
- Keeping spares in a hardware bag for gig-night failures
Consider the trade-offs
When to look elsewhere
- Stands with 8 mm threaded tilters
- Anyone needing felts, wing nuts, or washers as well
- Quick-release setups that use a different mounting system
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Wing style
The flange at the base sits between the cymbal and the lower felt so the cymbal never touches the rod threads.
Detail 03
4-pack
Enough for a small setup: crash, ride, splash, and a spare, or one full replacement round.
Detail 04
Plastic construction
Wears down under repeated hard playing. Cheap to swap, but inspect for splits when you change heads.
Final check
Know before you order
- 01Check whether your stand rods are 6 mm or 8 mm before ordering
- 02Felts and wing nuts are separate items, not included here
- 03A torn sleeve is the usual cause of keyholed cymbal mounting holes
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01How do I know if my stand is 6 mm?
Measure the threaded rod that passes through the cymbal hole. Lighter and entry-level stands commonly use 6 mm; heavier double-braced stands often step up to 8 mm.
02Do these come with felts?
No. This is sleeves only, four of them. You will need felt washers above and below the cymbal separately if yours are compressed or missing.
03Why do cymbal sleeves matter?
They keep the cymbal's mounting hole off the bare threaded rod. Metal on metal wears the hole into an oval over time, which is not repairable.
04Can I use these on a hi-hat clutch?
Yes, if the clutch rod is 6 mm. The top hi-hat cymbal needs the same protection from bare threads as any crash or ride.
