Detail 01
8 mm
The stand post diameter, not the cymbal hole. Measure your stand thread before ordering — 6 mm posts will not hold these.

Independent shopping perspective
Four 8 mm cymbal sleeves from Sound Percussion Labs. The plastic barrier between your cymbal's bell hole and the metal stand thread.

Strong match
Consider the trade-offs
What matters in use
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 01
The stand post diameter, not the cymbal hole. Measure your stand thread before ordering — 6 mm posts will not hold these.
Detail 02
Keeps the cymbal hole off the threaded rod. Without one, the thread saws at the hole and elongates it.
Detail 03
Four cymbal positions, one sleeve each. Enough for hats, ride, and two crashes on most kits.
Detail 04
Low enough to keep a spare set in the hardware bag permanently.
Final check
Product questions
Straight answers to the questions shoppers most often ask about this product.
Measure the threaded post the cymbal sits on. 8 mm is the common size on most modern stands; older or lighter stands sometimes use 6 mm.
The threaded metal rod cuts into the cymbal's bell hole, elongating it into a keyhole shape. That damage is permanent and hurts resale value.
No, sleeves only. Order felts separately.
If they're the same age, yes. They fail from the same wear, so one split usually means the rest are close behind.