Detail 01
Metal, not felt
Sits between the wing nut and the felt so tightening pressure spreads out instead of crushing one spot.
Product detailSKU #1274115065079
Sound Percussion LabsSPC09 Metal Cymbal Washer 4-Pack
1/2
Independent shopping perspective
The Korena take
Four metal washers for cymbal stands, sold as spares. Buy if your wing nuts are biting into the felts or a washer went missing.
Strong match
Who this is for
- Replacing washers lost during teardown at gigs
- Stands where the wing nut chews the top felt
- Spares kept in a stick bag or hardware case
Consider the trade-offs
When to look elsewhere
- Players who actually need felts or sleeves — different parts
- Anyone wanting a quick-release cymbal nut instead
- Stands whose wing nut already has a captive washer built in
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Four in the pack
Covers two stands top and bottom, or one stand plus spares for the ones you lose first.
Detail 03
Slides over the rod
No threads to match. Fit comes down to whether the hole clears your stand's tilter rod.
Detail 04
Washer only
Replaces one piece of the cymbal stack. Felts, sleeves and wing nuts stay as they are.
Detail 05
Entry-level price
Cheap enough to keep a set in every hardware bag rather than hunting a single washer down mid-teardown.
Final check
Know before you order
- 01No felts, sleeves or wing nuts included — order those separately
- 02Check that your tilter rod diameter clears the washer's hole
- 03Keep felt between metal and cymbal; a washer must never touch bronze
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Do these go above or below the felt?
Above the top felt, under the wing nut. The felt stays against the cymbal; the washer only spreads the nut's pressure so it doesn't dig into the felt.
02Do they come with felts?
No. Four metal washers only. Felts, sleeves and wing nuts are separate parts.
03Will they fit any cymbal stand?
They slide over the tilter rod, so fit depends on the hole clearing that rod. Standard full-size cymbal tilters are the usual case; measure if your stand is unusual.
04Can I use one on a hi-hat clutch?
Only if the clutch rod passes through the hole. Clutches use their own felt arrangement, so check before you rebuild the stack.
