Detail 01
Felt strips
Felt damps by touching the head surface, which shortens sustain while leaving the initial attack intact.

Independent shopping perspective
Two felt strips that sit against the bass drum head to tame ring. For drummers chasing a shorter, drier kick sound.

Strong match
Consider the trade-offs
What matters in use
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 01
Felt damps by touching the head surface, which shortens sustain while leaving the initial attack intact.
Detail 02
Enough for one drum with two strips, or two drums with one strip each depending how dry you want it.
Detail 03
Sized for a kick. Not intended as snare or tom muffling.
Detail 04
Consumable hardware. Cheap enough to keep spares and experiment with placement.
Final check
Product questions
Straight answers to the questions shoppers most often ask about this product.
Loosen the tension rods, lift the head off, lay the strip across the shell so it presses against the inside of the head, then reseat and retune the drum.
One strip gives light damping and keeps some resonance. Two strips, or one under each head, gives a shorter, drier note. Start with one and add if it still rings.
These are cut for a bass drum. On smaller drums they are oversized and awkward, so use a muffling ring or gel made for those sizes.
Either works. Under the batter head it shortens the attack side; under the front head it controls the resonant ring. Many drummers run one under each.