Detail 01
80W power rating
High handling for a single 12". The speaker stays composed rather than adding its own breakup at volume.
Product detailSKU #1273887991517
CelestionClassic Lead 80 80W, 12" Guitar Speaker 16 Ohm
Independent shopping perspective
The Korena take
An 80W 16 ohm 12" guitar speaker. For higher-output amps and cab builds where 16 ohm wiring is what the amp or the other drivers call for.
Strong match
Who this is for
- Amps with a 16 ohm speaker output driving one 12"
- Cab builds where you want power handling over early breakup
- Replacing a blown 16 ohm driver in an existing cabinet
Consider the trade-offs
When to look elsewhere
- Amps whose lowest output impedance is 8 or 4 ohms
- Bass or full-range playback — it's a guitar speaker
- Players wanting the speaker to distort before the amp does
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
16 ohms nominal
Must match your amp's output. Two in parallel gives 8 ohms; four in a series-parallel 4x12 gives 16.
Detail 03
12" driver
Standard guitar speaker size. Fits typical 1x12, 2x12 and 4x12 baffles cut for a 12".
Detail 04
Guitar-voiced design
Limited high-frequency extension by design, so distorted tones stay thick instead of turning brittle.
Final check
Know before you order
- 01Speaker only — no wiring, hardware, gasket, or connectors
- 02Verify your amp supports a 16 ohm load before ordering this version
- 03Measure your baffle cutout and rear depth clearance first
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Can I use a 16 ohm speaker with my 8 ohm amp?
Not on its own. Tube amps in particular need a matched load. Two of these wired in parallel give 8 ohms, which does match.
02How much power can it take?
80W continuous — enough for most single-speaker guitar rigs, including 50W and many 100W heads in a single-driver cab.
03Will it fit my 4x12?
It's a standard 12" driver. Confirm your cutout diameter, bolt pattern and rear clearance, since baffle cuts vary between builders.
04Do I need any other parts?
You'll need mounting hardware and speaker wire if you're not reusing what's in the cab. Most installs also require soldering.
