Detail 01
0.66 to 1.13 inch mic diameter
The hard compatibility limit. Measure your mic barrel at the widest point before ordering.
Product detailSKU #1273887989094
Audio-TechnicaAT8410a Shockmount
1/4
Independent shopping perspective
The Korena take
Shockmount that isolates a mic from stand and floor vibration. Buy it if your mic body measures between 0.66 and 1.13 inches.
Strong match
Who this is for
- Studio or booth setups on floors that transmit footsteps
- Desk-mounted arms where keyboard and typing thumps travel up
- Any mic with a body diameter inside its clamp range
Consider the trade-offs
When to look elsewhere
- Handheld mics used in the hand, where isolation does nothing
- Mic bodies thinner than 0.66 inch or wider than 1.13 inch
- Anyone needing a pop filter — this handles vibration, not plosives
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
3.11 inch ring diameter
The suspension ring. Check clearance if you mount close to a screen, a wall, or another mic.
Detail 03
5.23 inch height
Adds over five inches above the stand thread, so your stand needs to sit lower than usual.
Detail 04
6.3 g
Almost nothing. It will not change how a stand or boom arm balances.
Final check
Know before you order
- 01No microphone included. This is the mount only.
- 02Measure your mic barrel first — outside 0.66 to 1.13 inch it will not hold.
- 03Isolates vibration through the stand, not room noise or breath pops.
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Will this fit my microphone?
It fits mic bodies from 0.66 to 1.13 inch in diameter. Measure the widest part of the barrel where the mount grips and compare.
02What does a shockmount actually do?
It suspends the mic in elastic so vibration traveling up the stand from footsteps, desk bumps, or building rumble does not reach the mic element.
03Does it work as a pop filter?
No. Plosives are air hitting the capsule, which is a separate problem. You still need a pop filter or windscreen for close vocal work.
04Does it fit standard mic stands?
It mounts to a stand thread like any mic clip. Confirm your stand thread size and use a thread adapter if the two do not match.
Reference
Full specifications
The complete catalog record, organized around the decisions musicians make when comparing gear.
1 detailsBody & build
- Color
- Black
5 detailsSize & weight
- Maximum Microphone Diameter
- 1.13 inch (28.8 mm)
- Weight
- 6.3
- Ring Diameter
- 3.11 inch (79 mm)
- Minimum Microphone Diameter
- .66 inch (16.8 mm)
- Height
- 5.23 inch (133.3 mm)
