Detail 01
Typical operating range: 300 ft / 100 m
The stated range applies to an open environment with no interfering signals.
Product detailSKU #1500000318654
Audio-Technica3000 Series (4th Gen) Network Enabled UHF Wireless with ATW-C710 Cardioid Dynamic Microphone Capsule Band DE2
1/7
Independent shopping perspective
The Korena take
Built around the DE2 band, this fourth-generation 3000 Series package pairs an ATW-R3210N network-enabled receiver with an ATW-T3202 handheld transmitter and ATW-C710 capsule. Frequency scanning happens at the receiver, with IR sync sending the selection to the transmitter. You can also store a backup frequency and switch to it from the transmitter’s multifunction button if interference interrupts operation. A-T Wireless Manager software provides network-based monitoring and control; the receiver retains a balanced XLR output rather than a 1/4-inch audio output.
Strong match
Who this is for
- DE2-band operation across 470.125–529.975 MHz with receiver scanning and IR frequency synchronization.
- Wireless microphone systems that need network monitoring and control through A-T Wireless Manager software.
- Performances where a backup frequency can be switched from the handheld transmitter.
Consider the trade-offs
When to look elsewhere
- Systems requiring a 1/4-inch audio output from the network-enabled receiver.
- Applications expecting audio to travel over the system’s network connection.
- Operation outside the DE2 470.125–529.975 MHz frequency band.
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
True-diversity receiving system
The receiver is specified as true diversity.
Detail 03
Switchable RF output: 10 mW or 30 mW
The transmitter offers two listed RF power settings.
Detail 04
Two AA batteries
The handheld transmitter uses two AA batteries; batteries are not included.
Detail 05
AT8631 joining plate
A joining plate is included with the network-enabled system.
Final check
Know before you order
- 01Use the DE2 frequency band: 470.125–529.975 MHz.
- 02Plan for a balanced XLR receiver connection; this network-enabled version has no 1/4-inch audio output.
- 03The network port supports monitoring and control, not network audio.
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01What frequency range does the DE2 version use?
The DE2 band covers 470.125 to 529.975 MHz.
02Can I manage it over a network?
Yes. The network-enabled receiver supports monitoring and control through A-T Wireless Manager software; it does not carry network audio.
03How are transmitter frequencies set?
Scan and select a frequency on the receiver, then use IR sync to transfer it to the transmitter.
04Are batteries included?
No. The transmitter requires two 1.5V AA batteries, which are not included.
Reference
Full specifications
The complete catalog record, organized around the decisions musicians make when comparing gear.
3 detailsSound
- Minimum Frequency Step
- 25kHz
- Frequency Response
- T3201: 40Hz-13kHz (-3dB)
- Rf Sensitivity
- 20dBuV at 60dB S/N ratio
4 detailsConnections & power
- Rf Power Output
- High: 30mw, Low: 10mWat 50Ω, switchable
- Antenna Input
- BNC-Type, 50Ω
- Power Requirements
- 12V, 1A
- Maximum Output Level
- XLR. Balanced: +14dBV
3 detailsSize & weight
- Net Weight
- 0.44 lb (without capsule)
- Weight
- 2.4
- Dimensions
- 7.5” x 1.5” (without capsule)
1 detailsIn the box
- Accessories Included
- AT8456a
15 detailsOther
- Operating Frequencies
- Band DE2: 470.125 to 529.975 MHz
- Moderation Mode
- FM
- Image Rejection
- 60dB nominal
- Spurious Emissions
- Following federal and national regulations
- 30mw
- 9 hours
- Operation Temperature Range
- 23°F to 113°F (Battery performance may be reduced at very low temperatures)
- Operating Range
- 100m (300'), typical (Open range environment with no interfering signals)
- Band Ee1
- 530.000 to 589.975 MHz
- Bias
- 12VDC, 160mA total
- Microphone Element
- Interchangeable industry standard thread
- Total Harmonic Distortion
- < 1% (at 1kHz, 17.5kHz deviation)
- Receiving System
- True diversity
- 10mw
- 9.5 hours
- Batteries
- Two 1.5V AA, not included
- Dynamic Range
- 115dB (A-weighted), typ.
