Detail 01
Mono 1/4-inch (tip-sleeve)
Two conductors, one channel. Plugging it into a stereo TRS jack sends signal to one side and shorts the other.

Independent shopping perspective
A 1/4-inch mono male to RCA female adapter for plugging RCA cables into 1/4-inch inputs on mixers, amps, and interfaces.

Strong match
Consider the trade-offs
What matters in use
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 01
Two conductors, one channel. Plugging it into a stereo TRS jack sends signal to one side and shorts the other.
Detail 02
The plug goes into gear; the RCA socket accepts a cable. It adapts an RCA cable end, not an RCA jack.
Detail 03
No noise rejection over distance. Fine for a few feet next to the rack, noisy over a long stage run.
Detail 04
RCA sources run at consumer level, so you may need to push the input gain to reach a usable signal.
Detail 05
Priced to buy in pairs or handfuls. Losing one on a load-out costs nothing.
Final check
Product questions
Straight answers to the questions shoppers most often ask about this product.
No. The 1/4-inch end is mono tip-sleeve, so it passes one channel. For stereo you need two adapters and separate left and right runs.
Only if the turntable has a built-in phono preamp or you run it through one first. A bare phono output is too quiet and unequalized.
No. The 1/4-inch side is a plug and the RCA side is a socket, so it only works in that direction.
No. This is for line-level signal. Speaker connections carry far more current and need proper speaker cable.
Reference
The complete catalog record, organized around the decisions musicians make when comparing gear.