Detail 01
Hand-operated strippers
You control depth and pull, so practice on scrap first to avoid nicking conductor strands.
Product detailSKU #1273887987105
American Recorder TechnologiesWire Strippers
1/2
Independent shopping perspective
The Korena take
Basic hand wire strippers for cable work — soldering connectors, repairing patch leads and building your own signal cables.
Strong match
Who this is for
- Repairing a broken instrument or mic cable at home
- Building custom-length patch cables for a pedalboard
- Stripping speaker wire before terminating to a jack
Consider the trade-offs
When to look elsewhere
- Anyone with no soldering iron — stripping is only half the job
- Heavy-gauge electrical work outside audio cable ranges
- Players who just want a ready-made cable off the shelf
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Yellow handles
Easy to spot in a dark toolbox or on a cluttered stage floor.
Detail 03
Cable-focused tool
Sized for the small-gauge conductors and shielding found in audio cable, not house wiring.
Final check
Know before you order
- 01Solder, iron and connectors are all separate purchases
- 02Nicked shield strands are the usual cause of a buzzing rebuilt cable
- 03Heat shrink or connector strain relief is not included
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Can I repair a guitar cable with just this?
No. You also need a soldering iron, solder, and a replacement jack if the old one is damaged. This handles the stripping step only.
02Will it work on speaker cable?
Yes, for typical audio speaker wire gauges. Very heavy-gauge or armored electrical wire is outside what a cable stripper is built for.
03Do I need to strip the shield too?
Yes. On shielded audio cable you strip the outer jacket, separate and twist the shield, then strip the inner conductor.
04Is this better than using a knife?
Yes. A blade easily cuts into the conductor strands, which weakens the joint and causes intermittent signal later.
Reference
Full specifications
The complete catalog record, organized around the decisions musicians make when comparing gear.
1 detailsBody & build
- Color
- Yellow
