Detail 01
Pickguard-gauge screws
Short and fine-threaded, sized for thin guard material into the body. Longer screws risk hitting a route or wire.
Product detailSKU #1273888004467
FenderPickguard Screws
1/2
Independent shopping perspective
The Korena take
Fender replacement screws for mounting a pickguard. For anyone reassembling a guitar with stripped, rusted, or mismatched pickguard hardware.
Strong match
Who this is for
- Replacing rusted or stripped screws after a pickguard swap
- Restoring a project guitar with missing hardware
- Keeping matched screws on hand for setup work
Consider the trade-offs
When to look elsewhere
- Mounting control plates, necks, or tuners — wrong size
- Guitars with a mounted pickguard on a set of posts
- Anyone needing the pickguard itself
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Fender-spec sizing
Matches the hole spacing and diameter used on Fender guards, so they seat in existing holes without redrilling.
Detail 03
Sold as a set
All screws are the same length and head, so the guard sits flat instead of pulling unevenly.
Detail 04
Countersunk head
The head sits flush in the guard's bevelled holes rather than standing proud and catching your picking hand.
Final check
Know before you order
- 01The pickguard is not included
- 02Count your guard's holes — Strat guards use more screws than Tele
- 03Stripped body holes need a toothpick and glue fill before rescrewing
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01How many screws do I get?
This is sold as a set of pickguard screws. Check your guard's hole count before ordering, since Strat and Tele guards use different numbers.
02Will these fit a Squier or non-Fender guitar?
Usually yes for Strat and Tele style guards, since hole sizing is close. Test one screw before driving them all.
03What if the hole is stripped and the screw spins?
Fill the hole with a glued toothpick or wood sliver, let it dry, trim flush, then drive the screw. It will bite fresh wood.
04Can I use these for the control plate or jack plate?
No. Those use different lengths and head sizes. Use screws made for the part you are mounting.
