Detail 01
Set of four
Covers one standard bolt-on neck joint. Replace all four rather than mixing old and new so clamping pressure stays even.
Product detailSKU #1273888003851
FenderNeck Mounting Screws (4)
Independent shopping perspective
The Korena take
Set of four Fender neck mounting screws. Buy when the originals are stripped, rusted, or lost during a neck swap.
Strong match
Who this is for
- Replacing chewed-up or rusted screws on a bolt-on neck
- Finishing a partscaster build with matching Fender hardware
- Restoring a guitar after a neck pocket repair
Consider the trade-offs
When to look elsewhere
- Set-neck or neck-through instruments
- Anyone needing a neck plate or ferrules as well
- Non-Fender bodies with different screw spacing
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Fender spec threads
Sized for Fender neck pockets and pre-drilled neck holes. Off-brand bodies may use different diameters.
Detail 03
Wood screws, not bolts
They thread directly into the neck heel. Overtightening strips the wood, not the screw.
Final check
Know before you order
- 01Neck plate is not included
- 02Do not overtighten — snug is enough on a bolt-on joint
- 03If the old holes are stripped, plug and redrill before installing
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Will these fit my Squier or import Strat?
They are Fender spec. Many import bodies use a different screw diameter or hole spacing, so compare against an original screw before ordering.
02Do I get the neck plate too?
No. This is the four screws only. Buy the plate separately if yours is damaged or missing.
03How tight should they be?
Tighten until the neck seats firmly in the pocket, then stop. These bite into wood, and going past snug strips the heel.
04Can I use these on a bass?
Fender bass and guitar bolt-on joints use the same four-screw pattern, but confirm the screw diameter against your original before swapping.
