Detail 01
Gold finish
Matches gold knobs, tuners, and bridges. Plated finishes wear at contact points over years of handling.
Product detailSKU #1273888003725
FenderGold Pickguard Screws
Independent shopping perspective
The Korena take
Replacement pickguard screws in gold. For players matching screw hardware to gold-finished pickguards, knobs, and tuners on an existing guitar.
Strong match
Who this is for
- Completing a gold-hardware look after a pickguard swap
- Replacing stripped, rusted, or mismatched pickguard screws
- Keeping spares on hand for guitars with gold appointments
Consider the trade-offs
When to look elsewhere
- Anyone with chrome, nickel, or black hardware — the finish will clash
- Players needing structural body screws rather than pickguard screws
- Guitars whose existing holes are already stripped oversize
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Pickguard screws
Short, small-gauge screws sized for thin plastic into body wood. Not interchangeable with neck or strap-button screws.
Detail 03
Screw hardware only
Replaces the fasteners, not the pickguard. Existing hole spacing on the guitar determines where they go.
Final check
Know before you order
- 01Pickguard itself is not included
- 02Count your existing screws first — pickguards range from 8 to 11 holes
- 03Over-tightening into soft body wood strips the hole; snug is enough
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01How many screws come in this set?
The count varies by run, so check the quantity at checkout against the number of holes in your pickguard before ordering.
02Will these fit any pickguard?
They fit standard pickguard screw holes on Fender-style guitars. Very different hole diameters or thread sizes may not accept them.
03Will the gold plating wear off?
Plated finishes can wear where fingers, picks, and cloths contact them. Screw heads on a pickguard see less contact than knobs or bridges.
04Can I use these on a control plate or backplate?
Usually yes, if the hole diameter matches. Backplate and control plate screws are typically the same small gauge as pickguard screws.
Reference
Full specifications
The complete catalog record, organized around the decisions musicians make when comparing gear.
1 detailsBody & build
- Color
- Gold
