Detail 01
Band B frequency range: 572–596 MHz
This version operates within that specified frequency range.
Product detailSKU #1500000371077
SennheiserXSW IEM Wireless In-Ear Monitoring System - Band B
1/8
Independent shopping perspective
The Korena take
Sennheiser’s XSW IEM Band B system combines a wireless transmitter, a bodypack receiver that clips to a belt or strap, ear buds, and a rackmount kit. The transmitter’s LED display and straightforward controls provide access to 3-band EQ, a limiter, and Focus mode for tailoring a monitor mix and increasing one source within it. Band B covers 572–596 MHz.
Strong match
Who this is for
- Stage monitoring where a performer needs a belt-worn wireless receiver and included ear buds.
- Rack-based monitor setups requiring EQ, limiting, and Focus control from the transmitter.
Consider the trade-offs
When to look elsewhere
- Use in locations where the 572–596 MHz Band B range is not appropriate.
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
3-band EQ, limiter, and Focus mode
The transmitter provides bass, midrange, and treble adjustment, limiting, and single-source level increase.
Detail 03
Two AA batteries; approximately six hours of operation
The bodypack uses two 1.5V AA batteries; runtime varies with volume level.
Detail 04
Balanced AF inputs: two XLR/1/4-inch combo sockets
The transmitter provides two electronically balanced combo input sockets.
Final check
Know before you order
- 01Confirm that the 572–596 MHz Band B range suits your intended operating location.
- 02The bodypack receiver is powered by two 1.5V AA batteries.
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01What comes with the XSW IEM Band B system?
It includes a transmitter, bodypack receiver, ear buds, and rackmount kit.
02Can I adjust the monitor mix at the transmitter?
Yes. The transmitter includes 3-band EQ, a limiter, and Focus mode.
03What frequency range does Band B use?
Band B operates from 572–596 MHz.
Reference
Full specifications
The complete catalog record, organized around the decisions musicians make when comparing gear.
6 detailsSound
- Nominal impedance
- 6 ohm
- Variant C frequency range
- 662–686MHz
- Variant A frequency range
- 476–500MHz
- Variant E frequency range
- 823.2–831.8MHz
- AF frequency response
- 45Hz to 15kHz
- Variant B frequency range
- 572–596MHz
5 detailsConnections & power
- Antenna output BNC socket
- 50 ohm
- Variant A, B, C and E output power
- 30mW
- Variant K output power
- 10mW
- Nominal voltage
- 3V battery
- AF input
- BAL AF IN L (I) + MONO/ BAL AF IN R (II) - 2x XLR 3" and 1/4" jack combo socket, electronically balanced
2 detailsSize & weight
- Switching bandwidth
- Up to 24MHz
- Cable length
- 55.11"
24 detailsOther
- Nominal/peak deviation
- ±15kHz/±24kHz
- Connector
- 1/8" stereo plug, gold-plated
- Temperature
- –5 °C (23 °F) to +50 °C (122 °F)
- Total harmonic distortion (THD)
- ≤ 1%
- Power supply
- 2 AA batteries, 1.5V
- Tier
- new
- Modulation
- FM stereo
- Temperature range
- 0 °C to +40 °C
- Frequency response
- 40Hz–20kHz
- Variant K
- 925.2–937.3MHz
- SPL (1 kHz, 1 mW)
- 106dB
- Category Source
- detail
- Operating time
- Approx. 6 hr. (depending on volume level)
- RF Modulation
- Wideband FM
- High Boost (EQ)
- +10dB at 13kHz
- Cross talk (50Hz–10kHz)
- Typically 45dB
- Korena Special
- false
- IE 4 in-ear headphones transducer
- Dynamic
- Dimensions (WxHxD)
- 11.02" (28 cm) x 2.28" (5.8 cm)
- AF Signal-to-noise ratio (1 mV, peak deviation)
- - ≥88dB
- Signal-to-noise ratio (at nominal load and peak deviation)
- ≥88dB
- Source Id
- site51500000371077
- Weight (including batteries)
- Approx. 0.24 lb.
- Limiter
- -10dB
Worth comparing
1 of 12
