Detail 01
Dynamic capsule, no phantom power
Runs off any mic input. No 48V needed, so cheap mixers and passive splitters work fine.

Independent shopping perspective
Clip-on dynamic cardioid instrument mic for close-miking sources on a stage or in a room without eating up a mic stand.


Strong match
Consider the trade-offs
What matters in use
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.

Detail 01
Runs off any mic input. No 48V needed, so cheap mixers and passive splitters work fine.
Detail 02
Rejects sound from behind. On a loud stage that means less bleed from the monitor or the next drum over.
Detail 03
Low end reaches deep enough for floor toms and cabinets, with treble up top for stick attack.
Detail 04
Small and light enough to hang off a drum rim or cabinet edge without pulling itself out of position.
Detail 05
Attaches directly to the source. No boom stand, no counterweight, less clutter around the kit.
Detail 06
Standard balanced cable to any mixer or interface preamp. Long runs stay quiet.
Final check

Product questions
Straight answers to the questions shoppers most often ask about this product.
No. It is a dynamic mic and works off a plain mic input. Leaving 48V on will not harm it, but it is not required.
It is designed as an instrument mic and mounts by clip rather than in a stand holder, so it is a poor fit for handheld or stand-mounted vocal use.
The microphone, its clip, and a case. No cable and no stand.
Yes. Any XLR mic input works, and no phantom power is needed.
Reference
The complete catalog record, organized around the decisions musicians make when comparing gear.