Detail 01
Four channels
Receives four audio channels as part of the Catapult system.
Product detailSKU #1500000177733
Radial EngineeringCatapult 4-channel Cat 5 Audio Snake (RX4 Receiver Module)
1/4
Independent shopping perspective
The Korena take
The Catapult RX4 is the receiver-side module in Radial's four-channel Cat 5 audio-snake system. It receives analog or AES digital audio sent over shielded Cat 5 or Cat 6 twisted-pair cable, helping route balanced audio across larger stages or between rooms on a pre-wired network. A ground-lift switch at the Ethernet connection helps reduce hum and buzz associated with ground loops. Its 14-gauge steel enclosure is finished in powder coat for touring environments.
Strong match
Who this is for
- Receiving balanced audio at the far end of a stage run.
- Room-to-room audio routing through an existing shielded Cat 5 or Cat 6 network.
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Analog or AES digital audio over Cat 5/Cat 6
Uses shielded twisted-pair network cable for the audio run.
Detail 03
Ground-lift switch
Helps deal with hum and buzz caused by ground loops at the Ethernet connection.
Final check
Know before you order
- 01Use shielded Cat 5 or Cat 6 twisted-pair cable.
- 02The RX4 is the receiver module; pair the system with the required transmitter-side module.
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01What signals can the Catapult RX4 carry?
The Catapult system carries analog or AES digital audio.
02Why is there a ground-lift switch?
It helps eliminate hum and buzz caused by ground loops at the Ethernet cable connection.
