Detail 01
Omni / cardioid / figure-8 switch
Three placement approaches from one body — close-up isolation, full room capture, or two sources facing each other.

Independent shopping perspective
Multi-pattern large-diaphragm condenser in Neumann's TLM line. For a studio wanting three patterns and low noise in one mic.


Strong match
Consider the trade-offs
What matters in use
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.

Detail 01
Three placement approaches from one body — close-up isolation, full room capture, or two sources facing each other.
Detail 02
Cardioid is the quietest at 11 dB-A. Whispered vocals and distant sources stay above the mic's own hiss.
Detail 03
Requires 48V from your interface or preamp. Plug-in power or a bare mixer input will not run it.
Detail 04
Full-range pickup with proximity effect in cardioid and figure-8 — move closer and the low end swells.
Detail 05
Omni is the hottest output. On cardioid and figure-8 you will push the preamp gain a little harder.
Detail 06
Standard low-impedance output. It drives long XLR runs and mates with any normal mic preamp input.
Final check

Product questions
Straight answers to the questions shoppers most often ask about this product.
Cardioid rejects the rear for isolation, omni picks up all around for room sound, figure-8 takes front and back while rejecting the sides.
Yes, P48. Any interface, mixer or preamp with a 48V switch will work. Without it, the mic produces no output.
Self-noise is 11 dB-A in cardioid, 16 in omni and 17 in figure-8. Quiet vocals and fingerpicked acoustic stay above the noise floor.
XLR 3F, so a standard XLR mic cable. Output impedance is 50 ohms into a 1 kohm load, matching normal preamp inputs.
Reference
The complete catalog record, organized around the decisions musicians make when comparing gear.