Detail 01
Stereo 3.5mm (TRS) plug
Two channels on one small plug. Mates with headphone outputs on phones, laptops and portable players.

Independent shopping perspective
Ten-foot cable with a right-angle stereo 3.5mm plug on one end and a male XLR on the other. Runs a headphone output out to an XLR input.

Strong match
Consider the trade-offs
What matters in use
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 01
Two channels on one small plug. Mates with headphone outputs on phones, laptops and portable players.
Detail 02
Sits flat against the device so the plug isn't levered sideways when the cable is pulled or bagged.
Detail 03
Plugs into a female XLR input — console channel, stage box, powered speaker. It won't mate with another male XLR.
Detail 04
Crosses a small stage or reaches a nearby rack, short enough to coil without tangling.
Detail 05
No level control and no conversion. A hot headphone output arrives just as hot at the far end.
Final check
Product questions
Straight answers to the questions shoppers most often ask about this product.
Yes, the male XLR mates with any female XLR input. Start with the source volume low and bring gain up slowly, since headphone outputs are much hotter than a mic.
The 3.5mm end is stereo, but it lands on a single XLR connector, so plan on one channel at the far end rather than separate left and right.
Only toward an XLR input. It isn't a 3.5mm-to-3.5mm extension — the far end is an XLR plug, not a jack you can plug headphones into.
It sits flush against a phone or laptop so the plug isn't stressed sideways. Useful in a pocket, gig bag or tight rack space.
Reference
The complete catalog record, organized around the decisions musicians make when comparing gear.