Detail 01
Band D, 584–607 MHz
Fixed UHF range. Any other wireless in the room must sit outside these frequencies to avoid clashing.
Product detailSKU #1316705839096
Galaxy AudioPSER HANDHELD SYSTEM D
1/5
Independent shopping perspective
The Korena take
Handheld wireless mic system on band D (584–607 MHz). For speakers, singers and small venues that need one dependable channel at a low price.
Strong match
Who this is for
- Small church, school or meeting-room speech reinforcement
- A single vocal channel at bar gigs and open mics
- Roaming host or MC duties away from a mic stand
Consider the trade-offs
When to look elsewhere
- Multi-mic setups needing several coordinated channels at once
- Users who need a headset or clip-on mic instead of handheld
- Venues already using gear in the 584–607 MHz range
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
XLR and 1/4 inch outputs
XLR into a mixer channel; the 1/4 inch handles a powered speaker or small mixer with a jack input.
Detail 03
XLR output 200 ohms
Impedance balanced and low enough to run long cable to a mixer without picking up hum along the way.
Detail 04
Output level −12 dBV XLR
Hotter than a bare dynamic mic. Start the mixer preamp lower than you would for a wired handheld.
Detail 05
Image rejection over 90 dB
Reduces interference from strong off-frequency transmitters nearby, which matters most in urban venues.
Detail 06
Sensitivity −93 dBm for 30 dB
Sets how far the handheld can travel from the receiver before the audio starts to break up.
Final check
Know before you order
- 01Receiver needs an outlet — it runs on an external 12–18V DC supply at 400mA
- 02Pin 2 is audio and pin 3 is unused, so it is not a fully differential balanced output
- 03Receiver is 8.3 x 1.7 x 6.3 inches — check your rack shelf or table space
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Will this work with my powered speaker?
Yes. Use the XLR out to a mic or line input, or the 1/4 inch output if the speaker only has a jack input.
02How many can I use in one room?
Multiple units need separate frequencies. Two systems on the same band D channel will interfere, so coordinate channels before the event.
03Do I set the mixer input to mic or line?
Line is usually safer. The XLR output is around −12 dBV, hotter than a wired mic, so a mic preamp may need trimming.
04Can I use a lavalier with this system?
No. This is the handheld version of the PSE line. The lavalier setup is sold as a separate system.
Reference
Full specifications
The complete catalog record, organized around the decisions musicians make when comparing gear.
1 detailsSound
- Sensitivity
- -93dBm for 30dB
4 detailsConnections & power
- XLR Output
- Impedance balanced
- Output Impedance
- XLR connector 200Ohms ¼" connector 1KOhms
- Audio Output Level
- (+/-30KHz deviation, 1KHz tone) XLR connector (into 600 Ohms load) -12dBV ¼" connector (into 3KOhms load) -18dBV
- Power Requirements
- 12-18 V dc at 400mA, supplied by external power supply.
2 detailsSize & weight
- Weight
- 31
- Dimensions
- 8.3 x 1.7 x 6.3 in.
4 detailsOther
- Pin1
- Ground (cable shield)
- Pin2
- Audio
- Pin3
- No Audio
- Image Rejection
- >90dB
