Detail 01
Impedance-balanced XLR output
Runs long cable to a mixer without picking up hum, the way a wired mic would.
Product detailSKU #1316705839396
Galaxy AudioPSE Headset System D
1/13
Independent shopping perspective
The Korena take
Wireless headset mic system for presenters, fitness instructors and worship speakers who need hands-free mobility and both XLR and 1/4 inch outputs.
Strong match
Who this is for
- Fitness instructors who need both hands free while moving
- Houses of worship feeding a mixer over balanced XLR
- Presenters plugging into a powered speaker's 1/4 inch input
Consider the trade-offs
When to look elsewhere
- Singers wanting a handheld vocal mic for stage
- Multi-mic setups needing many channels in one rack
- Studio recording where a wired condenser sounds better
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
XLR 200 ohms, 1/4 inch 1k ohms
XLR goes to a mixer mic input, 1/4 inch to a powered speaker or amp line input.
Detail 03
XLR -12dBV, 1/4 inch -18dBV output
The 1/4 inch jack runs quieter, so expect to add gain on that input.
Detail 04
Image rejection greater than 90dB
Rejects off-frequency radio interference, which matters in venues with other wireless gear nearby.
Detail 05
Sensitivity -93dBm for 30dB
Holds a usable signal at low RF levels, so range is not limited to the same room.
Detail 06
1.7 x 8.3 x 6.3 inch receiver
Half-rack sized. Sits on a shelf or next to a mixer rather than filling a rack space.
Final check
Know before you order
- 01Runs on an external 12-18V supply, so plan an outlet at the receiver
- 02Bring your own XLR or 1/4 inch cable to reach the mixer
- 03Headset mics need shaping on the board to avoid feedback at high volume
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Can I plug this straight into a powered speaker?
Yes, use the 1/4 inch output into a line input. It runs about 6dB quieter than the XLR out, so turn that channel up.
02Does it work with a regular mixer?
Yes. The impedance-balanced XLR output feeds a standard mixer input over normal mic cable.
03How is it powered?
An external supply provides 12-18V DC at 400mA to the receiver. The bodypack transmitter is powered separately.
04Can I run two of these at once?
Only on different frequencies. This is system D, so a second unit must be a different letter to avoid interference.
Reference
Full specifications
The complete catalog record, organized around the decisions musicians make when comparing gear.
1 detailsSound
- Sensitivity
- -93dBm for 30dB
4 detailsConnections & power
- XLR Output
- Impedance balanced
- Output Impedance
- XLR connector 200Ohms ¼" connector 1KOhms
- Audio Output Level
- (+/-30KHz deviation, 1KHz tone) XLR connector (into 600 Ohms load) -12dBV ¼" connector (into 3KOhms load) -18dBV
- Power Requirements
- 12-18 V dc at 400mA, supplied by external power supply.
2 detailsSize & weight
- Weight
- 31
- Dimensions
- 1.7 inch x 8.3 inch x 6.3 inch
1 detailsOther
- Image Rejection
- >90dB
