Korena
Product detailSKU #1316705839311

Galaxy AudioPSE LAV System D

Galaxy Audio
Galaxy Audio PSE LAV System D
1/7

Independent shopping perspective

The Korena take

Lavalier wireless system on band D (584–607 MHz). For presenters, worship leaders and video work where hands stay free and the mic stays out of sight.

Galaxy Audio PSE LAV System D product detail
Product studyGalaxy Audio PSE LAV System D
Galaxy Audio PSE LAV System D alternate view
Alternate view

Strong match

Who this is for

  • Presentations and lectures where the speaker uses both hands
  • Worship or theater use with a discreet clip-on mic
  • Interview and video shoots feeding a mixer via XLR

Consider the trade-offs

When to look elsewhere

  • Singers who want a handheld mic to work close and loud
  • Rooms running several wireless channels without frequency coordination
  • Anyone needing a rechargeable receiver — this one requires wall power

What matters in use

The specifications, translated

Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.

Galaxy Audio PSE LAV System D construction detail

Detail 01

Band D, 584–607 MHz

Fixed UHF range. Other wireless in the building must be on different frequencies to stay clear of it.

Detail 02

XLR and 1/4 inch outputs

XLR feeds a mixer or camera input; the 1/4 inch covers a powered speaker or small jack-only mixer.

Detail 03

XLR output 200 ohms

Low impedance and impedance balanced, so long runs from the receiver to the console stay quiet.

Detail 04

Output level −12 dBV XLR, −18 dBV 1/4 inch

Line-ish rather than mic level. Set console gain lower than you would for a wired lavalier.

Detail 05

Image rejection over 90 dB

Blocks strong signals on nearby frequencies, which cuts down on the pops and dropouts common in busy RF areas.

Detail 06

Receiver 8.3 x 6.3 x 1.7 inches

Small enough for a shelf or podium, but it is a desktop box rather than something you clip to a camera.

Final check

Know before you order

  1. 01Receiver requires an external 12–18V DC supply at 400mA — an outlet is needed nearby
  2. 02Pin 2 carries audio, pin 3 does not; check this before wiring into a balanced snake
  3. 03Lavalier placement drives the sound — position it high on the chest, away from clothing rub
Galaxy Audio PSE LAV System D close-up

Product questions

Before you decide

Straight answers to the questions shoppers most often ask about this product.

01Can I plug this into a camera?

Only if the camera takes an XLR or 1/4 inch input. Output runs around −12 dBV at XLR, so set camera input to line and trim down.

02How far can the presenter walk?

Range depends on line of sight and RF conditions. Receiver sensitivity is −93 dBm for 30 dB, typical of entry-level UHF systems.

03Can I use two lavalier systems together?

Yes, but they must be on different frequencies. Two units sharing a band D channel will interfere and drop out.

04Can I swap in a handheld mic?

This system is built around the lavalier setup. The handheld version is sold separately in the same PSE line.

Reference

Full specifications

The complete catalog record, organized around the decisions musicians make when comparing gear.

1 detailsSound
Sensitivity
-93dBm for 30dB
4 detailsConnections & power
XLR Output
Impedance balanced
Output Impedance
XLR connector 200Ohms ¼" connector 1KOhms
Audio Output Level
(+/-30KHz deviation, 1KHz tone) XLR connector (into 600 Ohms load) -12dBV ¼" connector (into 3KOhms load) -18dBV
Power Requirements
12-18 V dc at 400mA, supplied by external power supply.
2 detailsSize & weight
Weight
31
Dimensions
1.7 inch x 8.3 inch x 6.3 inch
4 detailsOther
Pin1
Ground (cable shield)
Pin2
Audio
Pin3
No Audio
Image Rejection
>90dB

Complete your setup

Worth comparing

More from Galaxy Audio