Detail 01
6 filtered outlets
All six get noise filtering, not just surge protection. Cheap strips protect but don't filter.
Product detailSKU #1275425411050
FurmanPST-6 Power Station Series AC Power Conditioner
Sale
Independent shopping perspective
The Korena take
Six-outlet rack power conditioner with surge suppression and RF filtering. For rack rigs that need clean, protected AC in one 13.5-inch strip.
Strong match
Who this is for
- Amp or effects racks where a full-width conditioner won't fit
- Protecting tube amps and digital gear from surges on unfamiliar venue power
- Studio racks picking up buzz from lighting or dimmers
Consider the trade-offs
When to look elsewhere
- Players wanting front-panel lights, meters, or switched outlet banks
- Anyone needing more than six outlets or high-draw power amps near the 15A ceiling
- Regions on 220-240V mains
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
15 amps RMS total output
That's the combined ceiling for everything plugged in. A big power amp can eat most of it alone.
Detail 03
MOV shunt protection, L-N
Surge energy is clamped line-to-neutral. MOVs degrade with each hit, so protection wears down over years.
Detail 04
Over 40dB differential noise attenuation, 150kHz-100MHz
Cuts hash riding on the AC line. Helps with dimmer and switching-supply buzz, not ground-loop hum.
Detail 05
2.75 x 3.75 x 13.5 inches
Not a rack-width chassis. It mounts or sits inside a rack rather than filling a rack space.
Detail 06
Also protects telco and cable/satellite lines
Surges enter through coax and phone lines too, which matters for a rig with a landline or cable feed.
Final check
Know before you order
- 01Add the wattage of everything you'll plug in before assuming six outlets is enough
- 02Filtering won't fix hum caused by ground loops between amp and mixer
- 03Confirm your rack has depth and mounting hardware for a 13.5-inch strip
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Will this get rid of my amp's hum?
Only if the hum comes from noise on the AC line. Ground-loop hum between two grounded devices needs an isolation transformer or a ground lift, not a conditioner.
02Can I run my power amp through it?
Yes, if total draw across all six outlets stays under 15 amps. A large power amp can consume most of that on its own, leaving little for the rest.
03Does it have voltage regulation?
No. It filters noise and suppresses surges. Brownout correction and voltage regulation are separate features on higher-end units.
04Is it a standard rack unit?
It's a 13.5-inch strip, not a full-width rack faceplate. Plan on mounting it inside the rack rather than in a front panel space.
Reference
Full specifications
The complete catalog record, organized around the decisions musicians make when comparing gear.
2 detailsConnections & power
- Transient Voltage Surge Suppression
- 120 VAC-fused MOV shunt protection L-N, Telco, cable/satellite (less than .1dB insertion loss)
- Power Consumption
- 6W for display and control circuits independant of actual load
1 detailsSize & weight
- Dimensions Hxwxd
- 2.75 inch x 3.75 inch x 13.5 inch
4 detailsOther
- AC Current Capacity
- Input-15 amps capacity required, output-15 amps RMS (Maximum, all outlets combined-continous)
- Safety Agency Listing
- C-UL (UL standard #1449, #1363)
- AC Noise Attenuation
- Transverse (Differential) Mode: > 40dB from 150kHz-100 MHz
- Outlets
- 6 filtered outlets
