Detail 01
Female XLR
This is the end that plugs into a microphone. The male end goes to your mixer or interface.

Independent shopping perspective
A female XLR cable connector for building or repairing mic cables. For anyone assembling their own snakes and patch runs.

Strong match
Consider the trade-offs
What matters in use
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 01
This is the end that plugs into a microphone. The male end goes to your mixer or interface.
Detail 02
Standard balanced audio wiring: hot, cold and ground. Rejects noise over long cable runs.
Detail 03
Solders onto a cable end, not into a panel. For building or repairing loose cables.
Detail 04
Locks onto the mating plug and needs a button press to release. Won't pull out mid-performance.
Final check
Product questions
Straight answers to the questions shoppers most often ask about this product.
The end that plugs into the microphone. If your broken end connects to the mixer, you need the male version instead.
A soldering iron, wire strippers and helping hands. No crimper needed.
It is a standard 3-pin XLR, so it will physically mate with 3-pin DMX gear.
No. A finished mic cable needs this female end, a male end and bulk cable. All three are separate purchases.
Reference
The complete catalog record, organized around the decisions musicians make when comparing gear.