Detail 01
3-pin XLR-style connector
Fits 3-pin DMX outputs only. 5-pin fixtures need an adapter or a 5-pin terminator instead.
Product detailSKU #1274115056710
VTG3-Pin DMX Terminator
Independent shopping perspective
The Korena take
A terminating plug for the end of a 3-pin DMX chain. Buy it if your lighting rig drops or flickers cues on longer runs.
Strong match
Who this is for
- Lighting rigs where the last fixture behaves erratically
- Long DMX runs across a stage or venue
- Permanent installs where signal reliability matters
Consider the trade-offs
When to look elsewhere
- 5-pin DMX chains without a 3-to-5 adapter
- Short two-fixture setups that already run clean
- Anyone needing to extend a chain rather than end it
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Terminator, not a cable
It caps the last fixture's DMX output. It carries no signal onward and cannot join two devices.
Detail 03
Male plug convention
Goes into the DMX out jack of the final fixture in the chain, closing the line.
Detail 04
Black housing
Disappears on dark truss and backline. Worth tagging with tape so it doesn't get lost in a case.
Final check
Know before you order
- 01Check whether your fixtures use 3-pin or 5-pin DMX before ordering
- 02One terminator ends one chain — buy per universe, not per fixture
- 03Symptoms of a missing terminator are flicker and random cues, not total failure
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Do I really need a DMX terminator?
Short runs with a couple of fixtures often work without one. As the chain gets longer, signal reflections cause flicker and stray cues, and a terminator stops that.
02Where does it plug in?
Into the DMX output of the last fixture in the chain — the one with nothing connected after it.
03Will this work with 5-pin DMX?
Not directly. It is 3-pin. A 5-pin rig needs a 5-pin terminator or a 3-to-5-pin adapter.
04How many do I need?
One per DMX chain. If your controller runs multiple outputs or universes, each chain gets its own terminator at the far end.
Reference
Full specifications
The complete catalog record, organized around the decisions musicians make when comparing gear.
1 detailsBody & build
- Color
- Black
