Detail 01
Nine selectable polar patterns
Lets you choose a pickup pattern from the redesigned power supply for different recording needs.
Product detailSKU #1500000356998
Vanguard Audio LabsV4 Gen 2 Large-Diaphragm Multi-Pattern FET Condenser Microphone
1/5
Independent shopping perspective
The Korena take
Vanguard Audio Labs' V4 Gen 2 is a large-diaphragm, multi-pattern FET condenser built for detailed recording work. Its hand-tuned 34 mm capsule is voiced for balanced response, while the transformerless solid-state circuit provides wide dynamic range, low noise and 20 Hz–20 kHz response. Select among nine polar patterns at the redesigned power supply, then use the -10 dB pad or 120 Hz high-pass filter when the source calls for them. It is suited to vocals, acoustic instruments and drum overheads.
Strong match
Who this is for
- Recording vocals or acoustic instruments when a balanced response and detailed capture are needed.
- Using a single condenser for vocals, acoustic instruments, drum overheads, and other recording sources.
- Adapting microphone pickup with nine selectable polar patterns from the redesigned power supply.
Consider the trade-offs
When to look elsewhere
- Setups without the required phantom power.
- Connections that cannot accommodate its male 5-pin XLR output.
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
-10 dB pad
Attenuates high-SPL signals.
Detail 03
120 Hz high-pass filter
Reduces unwanted low frequencies.
Detail 04
Approximately 135 dB maximum SPL
Defines the microphone's stated high-SPL handling figure.
Detail 05
Equivalent noise level: ≤14 dBA, A-weighted
States the microphone's measured noise figure.
Final check
Know before you order
- 01Provide phantom power; +48 V is identified as ideal.
- 02Confirm your setup can connect to the microphone's male 5-pin XLR output.
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01What recording sources is the V4 Gen 2 described for?
It is described for vocals, acoustic instruments, drum overheads, and other recording sources.
02How are polar patterns selected?
The redesigned power supply provides nine selectable polar patterns.
03Does it have controls for loud sources and low-frequency reduction?
Yes. It has a -10 dB pad for high-SPL signals and a 120 Hz high-pass filter for unwanted low frequencies.
04What power does it require?
It requires phantom power, with +48 V identified as ideal.
Reference
Full specifications
The complete catalog record, organized around the decisions musicians make when comparing gear.
2 detailsSound
- Max SPL
- Approximately 135dB
- Frequency Response
- 20Hz–20kHz
3 detailsPickups & controls
- Attenuation Pad Switch
- -10dB
- Electronics Type
- Solid-state, electronically-balanced output
- High Pass Rolloff Switch
- 120Hz
2 detailsBody & build
- Body Finish
- Polished nickel trim, high-gloss Pinot Noir
- Finish
- Polished nickel trim, high-gloss Pinot Noir
3 detailsConnections & power
- Output Impedance
- 200 ohm
- Output Connector
- Male XLR 5-pin, gold-plated
- Voltage Requirement
- Phantom power (+48V ideal)
4 detailsSize & weight
- Dimensions Case Lxwxh
- 12 inch x 11 inch x 5.75 inch
- Dimensions Microphone Lxdia
- 7.25 inch x 1.8 inch
- Weight Microphone
- .83 lb.
- Weight in Case
- 5.63 lb.
5 detailsOther
- Transducer Type
- Condenser
- Diaphragm Size
- 1.04 inch
- Capsule Diaphragms Thickness
- 3µm
- Equivalent Noise Level
- <=14dBA (A-weighted)
- Capsule Size
- 1.34 inch dual-capsule
