Korena
Product detailSKU #1274115065093

Sound Percussion Labs20-Strand Snare Wires 14 In

Sound Percussion Labs
Sound Percussion Labs 20-Strand Snare Wires 14 In

Independent shopping perspective

The Korena take

Replacement snare wires for a 14-inch snare. Buy them when strands are bent or broken, or to keep a spare set in the case.

Sound Percussion Labs 20-Strand Snare Wires 14 In product detail
Product studySound Percussion Labs 20-Strand Snare Wires 14 In

Strong match

Who this is for

  • Replacing bent or snapped wires on a 14-inch snare
  • A backup set in the hardware case for gigs
  • A first wire swap on a starter kit

Consider the trade-offs

When to look elsewhere

  • 13-inch, 12-inch or piccolo snares — wrong length
  • Drummers wanting specialty wires: extended, coiled-end, high strand counts
  • Drums where the throw-off or snare bed is the real fault

What matters in use

The specifications, translated

Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.

Detail 01

20 strands

Fewer strands respond drier and more open; more add sizzle and can smother ghost notes. Twenty sits in the middle.

Detail 02

14 in.

Matched to drum diameter, not depth. A 14x5 and a 14x6.5 both take the same wires.

Detail 03

End plates

They anchor to the throw-off and butt plate. Centering them keeps the response even from side to side.

Detail 04

Budget tier

Priced as a consumable. Swap the whole set rather than trying to straighten one bent strand.

Detail 05

Flat strand set

Sits directly across the bottom head, so bottom-head tuning matters as much as the wires themselves.

Final check

Know before you order

  1. 01Back the throw-off fully off before fitting so you don't stretch the new wires
  2. 02Have straps or cord on hand in case yours are worn
  3. 03Measure the drum's diameter, not its depth, before ordering

Product questions

Before you decide

Straight answers to the questions shoppers most often ask about this product.

01Will these fit a 14x5.5 snare?

Yes. Wire length is matched to the 14-inch diameter. Shell depth makes no difference to the fit.

02How do I know when snare wires need replacing?

Bent or broken strands, an uneven buzz across the head, or wires that won't tension evenly end to end. One kinked strand is enough to ruin the response.

03Is 20 strands a lot?

It's a common general-purpose count. Sets range from around 12 up past 40. Higher counts add sizzle, lower counts sound drier and more controlled.

04Straps or cord — does it matter?

Cord lets you fine-tune tension at each end and is easier to replace. Straps are stiffer and quicker to set. Either mounts these fine.