Detail 01
20 strands
A middle count. More sensitivity and a fuller spread than 16 strands, less choked than 30-plus wire sets.
Product detailSKU #1274034479363
PuresoundCustom Series 20 Strand Snare Wire 13 in.
Independent shopping perspective
The Korena take
A 13-inch, 20-strand snare wire set. For players replacing dead or broken wires on a 13-inch snare drum.
Strong match
Who this is for
- Restoring snap to a snare that has gone dull or buzzy
- Replacing wires with a bent or snapped strand
- 13-inch snares on kits or in marching setups
Consider the trade-offs
When to look elsewhere
- 14-inch snares — the wire length will not seat correctly
- Players wanting a very dry, tight sound from higher strand counts
- Anyone whose problem is head tuning rather than worn wires
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
13 in. length
Sized to a 13-inch shell. Wires must span the snare bed with room for the straps at both ends.
Detail 03
Snare wire set
These sit against the bottom head and create the snare rattle. Nothing to do with the top playing surface.
Detail 04
Custom Series build
End plates and strand tension are matched so the set stays flat against the head instead of buzzing unevenly.
Final check
Know before you order
- 01Check your drum's diameter — 13 in. wires do not work on a 14 in. snare
- 02Straps or cord may not be included; keep your old ones if usable
- 03Set the throw-off tension slack first, then tighten evenly to avoid choking the drum
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Will 20 strands sound different from my stock wires?
If yours were 16 strands, expect more crispness and body. If they were 30, this will sound more open and sensitive at low volumes.
02Do these fit a 14-inch snare?
No. Use 14 in. wires on a 14 in. drum. Wires that are too short will not sit across the snare bed properly.
03How do I know my wires need replacing?
Look for bent, loose, or snapped strands, or a rattling response that no longer tightens up when you adjust the throw-off.
04Do I need any tools to install these?
A drum key to remove the bottom head, and usually a small screwdriver for the strainer and butt-plate screws.
