Detail 01
Gooseneck design
Bend it once to aim at mouth height and it holds position. No stand to knock over, no re-aiming between talkers.

Independent shopping perspective
Gooseneck condenser for lecterns and conference installs. The flexible neck aims it at a talker's mouth and stays where you put it.

Strong match
Consider the trade-offs
What matters in use
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 01
Bend it once to aim at mouth height and it holds position. No stand to knock over, no re-aiming between talkers.
Detail 02
Voiced for speech. The rolled-off bottom keeps building rumble and podium bumps out of the feed.
Detail 03
Won't distort on a loud, close talker. Handles someone leaning in and projecting.
Detail 04
Moderate output. Push a bit more gain at the preamp than you would with a handheld dynamic.
Detail 05
Low impedance balanced output drives long cable runs through a building without losing high end.
Detail 06
Room between the quietest usable signal and clipping, so a soft and a loud speaker both sit in range.
Final check
Product questions
Straight answers to the questions shoppers most often ask about this product.
Maximum SPL is 122.7 dB at 1 kHz, so a close, projecting talker won't clip it.
Yes. The neck holds its position once aimed, so it stays pointed at mouth height between users.
Frequency response runs 50 Hz to 17 kHz and is voiced for speech. Instruments and vocals with real low end won't be fully captured.
Open circuit sensitivity is -33.5 dB (21.1 mV) at 1 kHz. Expect to run the preamp higher than with a handheld dynamic mic.
Reference
The complete catalog record, organized around the decisions musicians make when comparing gear.