Detail 01
Humbucker
Two coils wired to cancel hum, so it stays quiet under amp gain and near screens or lighting.
Product detailSKU #1274034493655
Seymour DuncanSH-4 Humbucker Reverse Guitar Pickup Black and Cream
1/2
Independent shopping perspective
The Korena take
A hot ceramic bridge humbucker in reverse zebra, aimed at players who want a fatter, more compressed lead and rhythm tone than stock pickups give.
Strong match
Who this is for
- Bridge position in a humbucker-routed guitar needing more output
- Players chasing thick sustain for leads and heavy rhythm
- Swapping out a weak or muddy factory bridge pickup
Consider the trade-offs
When to look elsewhere
- Players wanting clean, glassy, open tones with lots of headroom
- Single-coil-routed guitars without a humbucker cavity
- Anyone unwilling to solder or pay for install
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Reverse black and cream
Bobbin colors are flipped from standard zebra. Purely cosmetic, but affects how the pickup reads visually.
Detail 03
Bridge-oriented output
Hotter output drives the amp front end harder, so distortion arrives sooner and cleans are less sparkly.
Detail 04
Passive pickup
No battery, no onboard preamp. Drops into standard guitar wiring and works with normal volume and tone pots.
Final check
Know before you order
- 01Soldering required. No wiring harness, pots, or switch included
- 02Confirm your guitar has a full humbucker route, not a single-coil slot
- 03Height adjustment after install changes output and string balance noticeably
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Will this fit my guitar?
It needs a standard humbucker-sized route. If your guitar has single-coil or P-90 slots, it will not drop in without routing or a mounting ring change.
02Do I need a battery?
No. This is a passive pickup. It runs off the string vibration and your existing guitar wiring, with no battery or preamp.
03Can I install it myself?
Yes, if you can solder. You need to desolder the old pickup leads and solder the new ones to your volume pot and switch.
04What is reverse black and cream?
The two bobbin colors are swapped compared to the standard layout. It changes the look only, not the sound or the wiring.
Reference
Full specifications
The complete catalog record, organized around the decisions musicians make when comparing gear.
1 detailsBody & build
- Color
- Black
