Detail 01
Needs 12–48V phantom power
The board or interface must supply it. Without phantom power the mic produces no signal at all.

Independent shopping perspective
Clip-on condenser built for miking horns and wind instruments. Buy it if you play a bell-mouth instrument and want to move while miked.


Strong match
Consider the trade-offs
What matters in use
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.

Detail 01
The board or interface must supply it. Without phantom power the mic produces no signal at all.
Detail 02
Handles the pressure right at a horn bell without the capsule breaking up. That is why it can sit close.
Detail 03
Rejects from behind, so the drummer and the wedge stay out of your channel even at close range.
Detail 04
Faster and more detailed than a dynamic. It captures the bite and breath of a horn rather than just the body.
Detail 05
Full range top to bottom, so brass upper harmonics and low reed body both come through.
Detail 06
Fine at close range on a loud horn. Back it off onto something quiet and the hiss becomes audible.
Final check

Product questions
Straight answers to the questions shoppers most often ask about this product.
No. It requires 12 to 48 volts of phantom power from your mixer, interface or an inline supply. It will not pass signal otherwise.
It is built and voiced for close-miking wind instruments at high SPL. A handheld vocal mic is the better tool for singing.
It clips to the bell and positions on a gooseneck, so it moves with the horn and holds the same distance while you play.
Yes. It takes 147dB before the capsule gives up, which covers a trumpet bell at close range.
Reference
The complete catalog record, organized around the decisions musicians make when comparing gear.