Detail 01
TRS on both ends
Three conductors carry a balanced signal, so induced hum cancels at the destination on long runs near power gear.
Product detailSKU #1274034477480
Rapco HorizonTRS-TRS Cable 15 ft.
Independent shopping perspective
The Korena take
A 15-foot balanced TRS-to-TRS cable for line-level connections between mixers, interfaces, powered monitors and outboard gear.
Strong match
Who this is for
- Interface outputs to powered studio monitors
- Mixer line outputs to powered speakers on a stage
- Insert-free balanced runs between rack gear
Consider the trade-offs
When to look elsewhere
- Guitar-to-amp use, where TS instrument cable is correct
- Amp-to-cabinet speaker connections
- Headphone extension or stereo signal on one cable
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Balanced connection
Only works if both devices have balanced TRS jacks. Plug into a TS jack and it reverts to unbalanced.
Detail 03
15-foot length
Reaches monitor stands or a rack across a room without excess cable pooling behind the desk.
Detail 04
Line-level cable
Built for signal between gear, not amplifier output to speakers, and not for high-impedance instrument pickups.
Final check
Know before you order
- 01Check both jacks are balanced TRS; TS jacks give you an unbalanced connection
- 02Sold individually, so stereo monitor pairs need two
- 03Not an insert cable; those split to two mono plugs at one end
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Can I use a TRS cable for my guitar?
It will pass signal into a standard TS jack, but the ring contact shorts to the sleeve and you get an unbalanced connection with no benefit. Use a proper instrument cable instead.
02Do I need one cable or two for studio monitors?
Two. Each powered monitor takes its own cable from a separate left and right output on your interface or mixer.
03What is the difference between TRS and TS?
TS has one ring and carries an unbalanced mono signal. TRS has two rings and a third conductor, which lets a balanced connection cancel noise picked up along the run.
04Will this work as an insert cable on my mixer?
No. Insert cables use one TRS plug that splits into two TS plugs for send and return. This is TRS on both ends, meant for straight balanced line runs.
Reference
Full specifications
The complete catalog record, organized around the decisions musicians make when comparing gear.
1 detailsBody & build
- Color
- Black
