Detail 01
1/4-inch high-impedance output
Provides the stated direct connection point for an amplifier or pedalboard.
Product detailSKU #1500000455026
Radial EngineeringSGI RX Instrument Line Driver System Receive
1/3
Independent shopping perspective
The Korena take
SGI-RX is the receiving end of Radial’s SGI instrument line-driver system. Used with the SGI-TX transmitter, it takes a guitar or bass signal after a balanced XLR run of up to 300 feet and provides a 1/4-inch high-impedance output for an amplifier or pedalboard. Jensen transformers support the signal path, and the ground-lift switch is there to address hum caused by ground loops. It fits remote amp, isolation-booth, and remote-recording setups.
Strong match
Who this is for
- Receiving an instrument signal at an off-stage amplifier after a long balanced XLR run.
- Connecting a remotely routed guitar or bass signal directly to an amplifier or pedalboard.
- Studio isolation-booth and remote-recording signal paths using an SGI-TX transmitter.
Consider the trade-offs
When to look elsewhere
- Use without an SGI-TX transmitter; the receiver is designed to pair with that transmitter.
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Ground-lift switch
Addresses hum caused by ground loops.
Detail 03
Up to 300 feet of balanced XLR cable
Receives signals sent across that specified XLR distance.
Final check
Know before you order
- 01The SGI-RX is intended to be used with the SGI-TX transmitter.
- 02Its output connection is a 1/4-inch high-impedance output for an amp or pedalboard.
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Can the SGI-RX be used by itself?
It is designed to pair with the SGI-TX transmitter.
02What can connect to the SGI-RX output?
Its 1/4-inch high-impedance output connects directly to amplifiers or pedalboards.
03What is the ground-lift switch for?
It is provided to eliminate hum caused by ground loops.
