Detail 01
14 in.
Matches the drum diameter, not the snare bed length. A 13-inch snare needs 13-inch wires.

Independent shopping perspective
Replacement snare wires for a 14-inch snare drum. For drummers whose current wires are bent, broken, or buzzing unevenly.

Strong match
Consider the trade-offs
What matters in use
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 01
Matches the drum diameter, not the snare bed length. A 13-inch snare needs 13-inch wires.
Detail 02
This is the coiled strand assembly under the bottom head, not the strainer or throw-off.
Detail 03
Puresound's line designation. Wire count and tension response differ across their series, so keep sets consistent.
Detail 04
Cheap enough to swap on a schedule rather than nursing bent strands along.
Final check
Product questions
Straight answers to the questions shoppers most often ask about this product.
Yes, if the drum is 14 inches in diameter. Check that your strainer uses standard end plates and that your existing mounting cord or straps are reusable.
You need to loosen the strainer and butt plate to release the old wires. The bottom head usually stays on, though loosening it makes the swap easier.
Sympathetic buzz is normal and often comes from wire tension. New wires seat evenly, which helps, but some buzz stays with any snare drum.
Assume not. Keep your existing cord or straps, or pick up a set at the same time so you are not stuck mid-repair.