Detail 01
3-pack
A locking nut uses three blocks, one per string pair, so this covers a full set.
Product detailSKU #1292606661806
ProlineFloyd Rose-Style Locking Nut Block w/ Screws 3 Pack Chrome
Independent shopping perspective
The Korena take
Three chrome Floyd Rose-style locking nut blocks with screws. Replacement clamping hardware for a double-locking trem guitar, useful mainly as spares.
Strong match
Who this is for
- Replacing a stripped or lost clamp block on a locking nut
- Keeping spares in a gig bag for a Floyd-equipped guitar
- A tech servicing several double-locking trem instruments
Consider the trade-offs
When to look elsewhere
- Guitars without a locking nut — these clamp strings, nothing else
- Anyone needing the full locking nut itself, not just the blocks
- Black or gold hardware builds where chrome will stand out
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Includes screws
The clamp screws strip and gall over time; getting fresh ones matters as much as the blocks.
Detail 03
Chrome
Matches the most common Floyd hardware finish. Wipes clean but shows sweat pitting on a heavily played guitar.
Detail 04
Floyd Rose-style, not Floyd Rose branded
Dimensions follow the common pattern rather than one licensed spec, so fit varies by nut.
Detail 05
$22.99
Priced as a service part, well under replacing an entire locking nut assembly.
Final check
Know before you order
- 01Measure your old block — licensed and import locking nuts vary in width and thickness
- 02Blocks sit under string pressure; you must detune to swap them
- 03You will likely need to reset trem spring tension and intonation afterward
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Will these fit my licensed Floyd Rose?
Often, but not guaranteed. Locking nut block sizes differ between original, licensed, and import units. Compare your existing block's width and thickness before installing.
02How do I install them?
Detune, back off the clamp screws, lift the old block out from the top of the nut, drop the new one in, retune and re-clamp.
03Do I need all three?
A standard six-string locking nut takes three, each clamping two strings. This pack covers a full nut or gives you two spares.
04Why does my clamp block keep slipping?
Usually a worn block face or a stripped clamp screw. Both wear together, which is why replacing the block and screw at once helps.
