Detail 01
Male XLR
This is the output end. It mates with the female input on a mixer, interface, or the next cable in the chain.
Product detailSKU #1274115056567
NeutrikXLR Male Right Angle Connector
Independent shopping perspective
The Korena take
A bare male XLR connector with a right-angle body, for building or repairing mic and line cables where a straight plug won't fit.
Strong match
Who this is for
- Cables feeding gear mounted flat against a wall or rack
- Pedalboard and stage boxes where a straight barrel gets kicked
- Rebuilding a mic cable end that failed at the strain relief
Consider the trade-offs
When to look elsewhere
- Anyone who just needs a finished cable — this is a part
- Players without a soldering iron and basic wiring skills
- Connecting into a recessed or tightly shrouded panel jack
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Right angle
Exits the connector sideways instead of straight out, cutting the clearance a cable needs behind gear by several inches.
Detail 03
Connector, not a cable
You supply the cable and do the wiring. Three pins to terminate: hot, cold, and shield.
Detail 04
Neutrik
Standard industry housing dimensions, so it fits panel jacks and cable clamps that other pro connectors do.
Detail 05
Gray shell
Housing color only. Useful if you color-code ends to track channels in a large loom.
Detail 06
$23.99 each
Priced per connector. A full cable needs two ends, so budget accordingly before ordering.
Final check
Know before you order
- 01No cable included. Buy mic cable separately and match the connector's cable diameter range
- 02Requires soldering and heat-shrink or equivalent; not a screw-terminal part
- 03The angle direction is fixed once assembled — plan cable exit before you close it up
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Is this a finished cable?
No. It's a single connector end. You solder it onto bulk mic cable yourself, and you'll need a second connector for the other end.
02Male or female — which do I need?
Male XLR is the output side. It plugs into the female input on a mixer, preamp, or interface. Mics themselves have male outputs.
03Why pay more than a generic connector?
Neutrik housings hold consistent dimensions and strain relief, so they seat properly in panel jacks and survive repeated plug cycles on stage.
04Will the right angle fit any jack?
It fits standard XLR panel jacks. Recessed or deeply shrouded jacks can crowd the angled body, so check clearance on tight rear panels first.
Reference
Full specifications
The complete catalog record, organized around the decisions musicians make when comparing gear.
1 detailsBody & build
- Color
- Gray
