Detail 01
15-foot length
Crosses a control room or reaches a rack without leaving coiled slack piled behind the desk.
Product detailSKU #1275776902236
MogamiGold Studio 1/4" to XLR Male Cable - 15 ft.
Independent shopping perspective
The Korena take
A 15-foot studio cable running a quarter-inch output into an XLR input. For keyboards, outboard gear and line-level sources feeding a mixer or interface.
Strong match
Who this is for
- Sending a keyboard or synth output to a mixer channel
- Patching outboard gear into an XLR input across a control room
- Studio runs where you want one cable, not an adapter stack
Consider the trade-offs
When to look elsewhere
- Plugging a guitar straight into a mic input; use a DI
- Guitar-to-amp use — an instrument cable is the right tool
- Short pedalboard or rack patching; fifteen feet is excess
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Quarter-inch one end, XLR male the other
One-piece cable rather than a cable plus adapter, so no barrel hangs off the jack.
Detail 03
Male XLR end
Mates with the female XLR inputs found on mixers, interfaces and outboard preamps.
Detail 04
Studio cable, not an instrument cable
Aimed at line-level gear-to-console runs rather than a guitar's high-impedance pickup output.
Detail 05
Black jacket
Disappears against dark racks and stands, though it's harder to pick out of a tangled pile.
Final check
Know before you order
- 01Check whether your quarter-inch output is TS or TRS before counting on a balanced run
- 02Instrument-level sources into a mic input usually need a DI box first
- 03One cable carries one channel; a stereo keyboard needs a pair
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Can I plug my guitar into an interface with this?
Use the interface's instrument input with a plain instrument cable, or a DI box. A guitar's pickup output into a mic input loses both level and tone.
02Will this work for a keyboard into a mixer?
Yes, that's the common use — keyboard quarter-inch output into a mixer's XLR input. Buy two if the keyboard has stereo outputs.
03Is it a balanced connection?
The XLR end is a three-pin connection. Whether the full run stays balanced depends on the source: a TRS output keeps it balanced, a TS output does not.
04Is fifteen feet too long for line level?
No. Line-level signal travels that far without meaningful loss. At this scale, length is about reach and slack rather than sound.
Reference
Full specifications
The complete catalog record, organized around the decisions musicians make when comparing gear.
1 detailsBody & build
- Color
- Black
