Detail 01
Flex life of 16,000 to 26,000 cycles
Rated for repeated bending at the same point. That is the spec that matters for a cable dragged around a room daily.
Product detailSKU #1275776902279
MogamiGold Headphone Extension Cable 25 ft.
Independent shopping perspective
The Korena take
A 25 ft Mogami Gold headphone extension cable. For engineers and musicians who need to move away from the desk without unplugging.
Strong match
Who this is for
- Tracking in a live room while the interface sits in control
- Drummers and engineers who need reach from the headphone amp
- Long-term studio installs where cables get stepped on daily
Consider the trade-offs
When to look elsewhere
- Desk-side listening where the stock cable already reaches
- Portable or commuting use — 25 ft is far too much
- Anyone needing an instrument, mic or speaker connection
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Microphonics of 30 to 40 microvolts max
Handling and floor noise picked up by the cable itself. Low microphonics means you do not hear the cable move.
Detail 03
Capacitance of 57 pF per meter
Low enough that 25 ft of extension has no audible effect on headphone response. Headphone outputs are low impedance.
Detail 04
Tensile strength up to 539 N
It survives being yanked. In a studio the failure is usually someone tripping, not the wire wearing out.
Detail 05
Operating range of -20 to +70 C
Fine anywhere you would actually work, including hot racks, backline trunks and outdoor summer gigs.
Detail 06
Electrostatic noise of 50 microvolts max
Resists the static crackle a long cable can pick up when dragged across carpet or coiled near power runs.
Final check
Know before you order
- 01Confirm your headphone plug size matches — an extension is not an adapter
- 02This extends an existing headphone cable; it does not replace a detachable one
- 03Tape or route 25 ft properly in a live room so nobody trips on it
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Will 25 feet of extension make my headphones quieter?
Not meaningfully. Headphone outputs drive low impedance, and this cable's resistance and capacitance are low enough that level and frequency response stay effectively unchanged.
02What plug size does it use?
Plug size is not listed here. Check your headphone connector and the amp output before ordering, since an extension has to match on both ends.
03Can I use it as an instrument cable?
No. This is wired for stereo headphone signal, not a mono instrument connection. Use a dedicated instrument cable for guitar or bass.
04Why does a headphone extension cost this much?
The spec that justifies it is durability: high flex life, high tensile strength and low handling noise. In a studio it outlasts several cheap extensions.
Reference
Full specifications
The complete catalog record, organized around the decisions musicians make when comparing gear.
1 detailsSound
- Characteristic Impedance 10mhz
- 75W
1 detailsBody & build
- Color
- Black
1 detailsConnections & power
- Voltage Breakdown
- Must withstand at DC 500V/15sec.
1 detailsIn the box
- Standard
- UL2552 AWM 30V 60 deg C VW-1
13 detailsOther
- Phase Constant 10mhz
- 0.3 rad/m
- Shield
- 0.025W/m(0.0076W/Ft): 0.025W/m(0.0076W/Ft)
- Insulation Resistance
- 100000 M W … m Min. at DC 125V, 20 deg C
- Emigration
- non-emigrant to ABS resin
- Capacitance At 1khz 20 Deg C
- 57pF/m(17.4pF/Ft): Ref. Quad Mic. Cables
- Flex Life
- 16,000 cycles: 16,500 cycles: 26,000 cycles
- Electrostatic Noise
- 50m V Max.: 50m V Max.
- Microphonics At 50kw Load
- 40m V Max.: 30m V Max.
- Inductance Between Conductors At 1khz 20 Deg C
- 0.4H/m(0.12H/Ft): 0.5H/m(0.15H/Ft)
- Applicable Temperature
- -20 deg C +70 deg C(-4 deg F +158 deg F)
- Tensile Strength
- 274N: 539N: 500N
- DC Resistance At 20 Deg C
- Inner Cond.: 0.083W/m(0.025W/Ft); 0.13W/m(0.040W/Ft)
- Attenuation 10mhz
- 0.0608 dB/m
