Detail 01
3.3 ft length
Enough for gear stacked or side by side. Measure before buying if anything sits across the room.

Independent shopping perspective
Stereo RCA-to-RCA pair, 3.3 ft, for hooking a turntable, mixer, or CD deck into a consumer input. Short run, low cost.

Strong match
Consider the trade-offs
What matters in use
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 01
Enough for gear stacked or side by side. Measure before buying if anything sits across the room.
Detail 02
Carries a stereo pair, left and right, in one cable. Not for mono routing.
Detail 03
No noise rejection built in, so keep runs short and away from power cables to avoid hum.
Detail 04
Meant for mixers, decks, and receivers, not for speaker outputs or instrument pickups.
Detail 05
Disappears behind a rack or console. Label both ends if you have several in a bundle.
Final check
Product questions
Straight answers to the questions shoppers most often ask about this product.
Yes, if the turntable has RCA outputs and either a built-in preamp or an external phono stage between it and your amp. Its 3.3 ft length suits gear on the same surface.
It covers gear stacked in a rack or sitting side by side on a desk. For anything across a room, choose a longer cable.
Only for powered speakers with RCA line inputs. Passive speakers need speaker cable from an amplifier, not this.
Stereo. Two RCA plugs at each end carry left and right channels.
Reference
The complete catalog record, organized around the decisions musicians make when comparing gear.