Detail 01
Dual conductors
One cable pair carries both left and right, so a stereo connection takes a single purchase.
Product detailSKU #1274034477560
HosaCPR-201 CPR-201 Dual RCA-1/4" 3.3' Cable
1/2
Independent shopping perspective
The Korena take
A short dual RCA to dual 1/4-inch cable pair for patching RCA outputs into 1/4-inch inputs on a mixer, interface, or powered speaker.
Strong match
Who this is for
- Sending a DJ mixer's RCA output to 1/4-inch inputs
- Patching a turntable preamp into an interface's line inputs
- Tight setups where gear sits within about three feet
Consider the trade-offs
When to look elsewhere
- Anyone needing balanced runs across a stage
- Setups where the gear sits more than three feet apart
- Direct guitar or microphone connections
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
RCA to 1/4-inch
Bridges consumer RCA outputs to the 1/4-inch jacks on mixers, interfaces, and powered speakers.
Detail 03
Unbalanced throughout
RCA is unbalanced, so the whole run is. Keep it short and away from power cables to avoid hum.
Detail 04
3.3 ft length
Short by design for stacked or side-by-side gear. Measure before ordering if anything sits apart.
Detail 05
Line-level use
Built for outputs already at line level. It will not boost a phono or microphone signal.
Final check
Know before you order
- 01Measure the distance first. Three feet disappears fast behind a rack
- 02Turntables without a built-in preamp still need a phono preamp
- 03Level mismatch is common. RCA outputs often run hotter or quieter than 1/4-inch inputs expect
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Can I plug my turntable straight into a mixer with this?
Only if the turntable has a built-in phono preamp or the mixer has phono inputs. A raw phono signal is far too quiet otherwise.
02Is this one cable or two?
It is a dual cable, so both left and right channels are covered in a single connection.
03Will the 1/4-inch ends work in balanced TRS jacks?
They will fit and pass signal, but the connection stays unbalanced because the RCA side has no balanced option.
04Is 3.3 feet enough for a DJ setup?
Enough for a mixer sitting next to an interface or amp. For anything across a booth, choose a longer cable.
Reference
Full specifications
The complete catalog record, organized around the decisions musicians make when comparing gear.
1 detailsBody & build
- Color
- Black
