Detail 01
TRS on one end, TS on the other
The stereo source collapses to a single mono conductor at the 1/4in end. You get one channel, not a stereo image.

Independent shopping perspective
A 10 ft patch cable that takes a 3.5mm stereo output into a mono 1/4in input. For getting a phone or laptop into a mixer or amp channel.

Strong match
Consider the trade-offs
What matters in use
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 01
The stereo source collapses to a single mono conductor at the 1/4in end. You get one channel, not a stereo image.
Detail 02
Fits standard instrument and line inputs on mixers, amps and DI boxes.
Detail 03
Fine at 10 ft near your gear. Long runs near power cables can pick up hum.
Detail 04
Reaches from a phone on a stand or music stand to a mixer or amp on the floor.
Final check
Product questions
Straight answers to the questions shoppers most often ask about this product.
The 1/4in end is mono, so the stereo source is reduced to one channel. Anything hard-panned may drop out or sound uneven.
Yes, if the amp has a 1/4in line or aux input. Start with the phone volume low.
The 1/4in end is a standard mono plug, but the other end is 3.5mm. It is for connecting small devices to 1/4in inputs, not for guitar to amp.
10 feet.
Reference
The complete catalog record, organized around the decisions musicians make when comparing gear.