Detail 01
TRS on both ends
Three conductors carry a balanced signal, which rejects hum picked up along the run. Both jacks must be balanced to benefit.

Independent shopping perspective
Ten-foot balanced 1/4" TRS cable, both ends the same. For line-level runs between mixers, interfaces, and powered speakers.

Strong match
Consider the trade-offs
What matters in use
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 01
Three conductors carry a balanced signal, which rejects hum picked up along the run. Both jacks must be balanced to benefit.
Detail 02
Reaches a monitor across a desk or a speaker at the edge of a small stage. Short for larger rooms.
Detail 03
The same three conductors can carry stereo for headphones, but between gear they carry one balanced channel.
Detail 04
The conductors are sized for signal, not amplifier output. Using it as a speaker cable risks heat and failure.
Detail 05
A guitar into a TRS jack can short or hum, since the instrument jack is two-conductor and the ring goes nowhere useful.
Final check
Product questions
Straight answers to the questions shoppers most often ask about this product.
It will pass signal, but an instrument jack is two-conductor. Use a TS instrument cable instead to avoid hum and intermittent contact.
Yes, if the monitors have 1/4" TRS inputs. You need one cable per monitor, so buy two for a stereo pair.
The wiring is the same. Between two pieces of gear it carries one balanced channel. In a headphone jack the same three conductors carry stereo.
No. That connection needs a speaker cable built for amplifier output. This one is for line-level signal only.
Reference
The complete catalog record, organized around the decisions musicians make when comparing gear.