Detail 01
Mono TS on both ends
One audio channel only. A stereo source connected here loses one side rather than blending both.

Independent shopping perspective
A ten-foot mono cable from 3.5mm to 1/4", for running a small device output into an amp, mixer, or recorder input.

Strong match
Consider the trade-offs
What matters in use
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 01
One audio channel only. A stereo source connected here loses one side rather than blending both.
Detail 02
Enough to cross a small stage or reach an amp from a table without coiling slack.
Detail 03
Bridges small consumer gear to full-size pro inputs without a stack of screw-on adapters.
Detail 04
Fine at this length. Push much further and it starts picking up hum near power gear.
Final check
Product questions
Straight answers to the questions shoppers most often ask about this product.
Yes. The 3.5mm goes into the headphone jack and the 1/4" into the amp input. Audio arrives mono.
Yes. Both ends are mono TS, so only one channel passes. For full stereo you need a stereo cable and two inputs.
No. It is a line-level interconnect. A guitar needs a 1/4" to 1/4" instrument cable.
No. Ten feet is fine for an unbalanced line run. Keep it away from power cables to avoid hum.
Reference
The complete catalog record, organized around the decisions musicians make when comparing gear.