Detail 01
6.56 ft (2 m) length
Covers one standard 2 m truss section. Longer spans need one cover per section, with seams at each joint.
Product detailSKU #1313854574616
Global TrussGTTC2.0 6.56 Ft. (2 M) Truss Cover For Box Truss
Independent shopping perspective
The Korena take
A 2 m fabric sleeve that hides a square box truss section. For event and DJ rigs where exposed aluminum breaks the look.
Strong match
Who this is for
- Corporate or wedding stages where bare truss reads as unfinished
- Uplit backdrops that need a clean vertical column
- DJ facades built from existing box truss lengths
Consider the trade-offs
When to look elsewhere
- Anyone needing structural or load-bearing hardware — this is cover only
- Triangle truss owners; it is cut for box truss
- Runs longer than 2 m without buying multiple covers
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Box truss fit
Sized for four-chord square truss. Triangle truss has a different cross-section and will not sit right.
Detail 03
Sleeve design
Slides over the truss, so it goes on before the section is joined into the rig, not after.
Detail 04
Fabric construction
Adds no meaningful load and no rigidity. Treat truss rating and rigging exactly as if the cover were not there.
Final check
Know before you order
- 01Truss is not included — this covers truss you already own
- 02Measure your section; 3 m or 1 m truss will not match
- 03Plan install order: sleeve slides on before sections are bolted together
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Does this fit triangle truss?
No. It is made for box truss, the square four-chord type. Triangle truss has a narrower three-chord profile and the cover will not sit correctly.
02How much truss does one cover?
One 2 m (6.56 ft) section. A 6 m run needs three covers, with a visible seam where each section meets.
03Can I hang lights through it?
Clamps need bare truss chord to grip. Plan cover placement for the sections between fixtures, not under clamps.
04Does it change the truss load rating?
No. It adds a fabric sleeve and nothing structural. Rig to the truss manufacturer's ratings as usual.
