Detail 01
6 rack spaces
Each space is 1.75 inches of front panel. Add up your gear's rack units and leave one free.
Product detailSKU #1274228064075
GatorGR Deluxe Rack Case 6 Space
1/10
Independent shopping perspective
The Korena take
Six-space rack case for mounting outboard gear. For players and engineers who move a small rack rig instead of leaving it in a studio.
Strong match
Who this is for
- A power conditioner, wireless receivers and a preamp in one carry
- Weekly gigs where the rig is loaded and unloaded by hand
- Pulling scattered half-rack boxes into a single enclosure
Consider the trade-offs
When to look elsewhere
- Rigs needing more than six rack units of front panel
- Studio-only setups — fixed furniture racks cost less and hold more
- Very deep power amps if they exceed the case's rail depth
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Rack rails
Gear bolts to threaded rails at the front. Nothing sits in here loose — you need screws for every unit.
Detail 03
Rigid case, not a rack bag
Takes edge and corner impacts a padded bag won't. It also weighs more before you load anything.
Detail 04
Internal depth
Rear clearance decides fit more often than spaces do. Measure your deepest unit plus the cable bend behind it.
Detail 05
Price relative to rack bags
The premium buys the shell and hardware, not extra spaces. A bag of the same size holds the same gear.
Final check
Know before you order
- 01Rack screws and plastic washers are usually a separate purchase — buy them ahead
- 02Mount the heaviest unit at the bottom or the rack tips when set down
- 03Leave a blank space above anything that runs hot; enclosed racks trap heat
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01How much gear is six spaces?
Six single-rack-unit boxes, fewer if anything is 2U or 3U. A power conditioner plus a wireless system typically uses about three.
02Will a power amp fit?
That's a depth and weight question, not a space question. Confirm the amp's chassis depth against the rails and mount it at the bottom.
03What do I need to mount gear in it?
Rack screws with plastic washers and a screwdriver. Match the screw thread to the rails and stop as soon as they're snug — overtightening cracks front panels.
04Can I fly with it?
Treat it as ground transport protection. Cargo handling calls for a purpose-built flight case, plus foam or removal of anything sticking out the back.
